NCS currently has a nice feature where the firmware versions are printed in the boot banner:
Is there a config option to also enable printing the nRF91 modem firmware...
Dear all,
after cutting the SB bridge to the QSPI chip and close the ones to get the pin free and disabled also qspi inside the nRF52840dk_nrf52840.overlay file I'm unable...
Hey, I have a problem understanding BLE behavior
I had a product was running in BLE phy 1M, and I wanted to convert it into PHY CODED.
It just sniffs all the advertisement...
Dear all,
I stubled upon the following issue when developing a BLE sensor product. When I try to bt_gatt_notify(); With only one characteristic, there is not an issue...
I was looking into the sdk provided by nordic for nrd52840Dk board and want to test the zigbee protocol. I havn't find any sdk for that.
Can you share me some links and...
Hello Team,
I want to configure P2.07 as UART RX for my custom board.
But when I clear the already assigned property as led2 for this pins from the pin editor gui, I am...
Hi,
I am trying to adding a coded phy support on my device in NCS project.
once I added CONFIG_BT_CTLR_PHY_CODED =y in my config , the ROM size will add more than 7kB...
I try to implement a BLE vendor service that has some characteristics. When I bonded the nRF devive (vendor service already download to device) with my Android phone and then...
Hello All,
I have modifies the Spi Master code to communicate with an ADXL345 Accelerometer. I set up my powermode and the percesion in the setup phase. However, when I send...
Hello, Nordic Team.
In my program, I have to change the value of the characteristic before start. I write:
case ACI_EVT_DEVICE_STARTED:
g_aci_state.data_credit_total...
Hello,
I want to make my Arduino coupled with the nrf8001 advertising a simple data (an integer). There should also be a possibility for dynamically changing the advertising...
I have a Jayconsystems breakout board for the nrf8002 bluetooth chip. Nothing is connected to the breakout board and the chip is unprogrammed. My current meter reads 6.0 mA...
The nRF8001 Product Spec says,
"Dynamic Window Limiting reduces the average current consumption by reducing the window widening of the receiver ... Enabling this feature...
Hello,
I am trying to play alarm in button click using nrf code. I am using Nordic nRF51822 device and trying to integrate with android device. When I am using linkloss then...
Hey guys,
Working with the simple be_app_beacon example on nRF51. I’d like to be able to stop and start advertising. But after stopping advertising, I’m unable to start...
Hi，
Can the examples in <keil_location>ARM\Pack\NordicSemiconductor\nRF_Examples\9.0.0 of PCA10028(nRF51422 chips) be use on nRF51822 chips? Or how to modify it to adapt...
Hi
in my application I use about 8 app_timer instantiations (so 8 x app_timer_create), with various frequencies.
I noticed now that one timeout handler is triggered twice...
any body know about android code for pairing with ble (nrf51dk)?
please help i want to pair my android app to the chip. app is discovering the chip but not able to connect...
Hi
nrf 52832 is able to run in 64 MHz using external 32 MHz crystal.
I wondered if I can use an external 16 MHz crystal, and get the CPU to run in 32 Mhz.
Thanks
...
Hi, All
sdk v7.2, IOS 9.1
I know after peering with IRK, iOS will connect 51822 actively.
There're some issue in my project. It's not certain happen.
At most of...
