Hi to all Nordic product lovers,
This is not a question but rather an announcement of a new nRF52840 based finger tip size module 14 x 9 x 1.6mm launched at CrowdSupply...
Hi,
I have a SPI slave device which outputs 8-bit registers that I have to assemble. For example, I receive two 8-bit registers, a high and a low register, which I have...
I have a PCA10059 dongle. I have inadvertently configured pin P0.25 as the sleep debug pin and I use active state 0 as I am using off board LEDs with reverse logic. This means...
If you're working on a product that requires you to show and translate GATT Attribute (Service, Characteristic and/or Descriptor) UUIDs to Strings to the user, it's likely...
Hello,
We have been trying the sendNotification call and after getting a success log we are not able to send a second notification. I'll copy the snippet of code that we...
I have a firmware developed on the nrf52840 development board. When porting it to nrf9160, a lot of errors were reported. How can I use the LOG output function on nrf9160...
Hi everyone,
Id like to know if anyone has tried to implement NFC Blocker Tag on NRF52480 or any similar nRF5 chip using their SDK. In general the purpose is to block a...
Hello! Is it possible to select to which interrupt types WFI (wake up from sleep mode) reacts?
I have a system with nRF51 where RTC clock initiates temperature measurements...
Hi,
The project "Thingy Mesh Provisioning Demo v0.7" which is available here on GitHub is for " Nordic nRF5 SDK for Mesh v3.2.0 "
Question: Is this project only supported...
Hi,
On our board, we have a nRF5340 + nRF9160 that turn on as soon as power is provided to the board.
We would like to reduce the inrush current drawn by these components...
Hi all,
I am working on CAN driver for the MCP25625 device, which communicates to the nrf9160 via SPI. I am following the SPI example https://github.com/Rallare/fw-nrfconnect...
Hi，
in the timeout_handler of app_timer_create, invoking function nrf_esb_write_payload(&tx_payload)，The timeout_handler function won't come in again，why? timer cancel?
Dear all,
I am using NRF52832 for a mesh application. I utilize the light switch example for the project.
Description of my application:
1. We have 6 devices. They...
I am trying to integrate LPS22hb sensor n nrf52832. I am starting with twi_master_using_nrf_twi_mngr example(sdk15a->compents->drivers_ext->lps22hb)
I have added lps22hb...
Hello,
I have a device that samples data from a bunch of sensors every n hours, and that when in IDLE must consume around 100uA. To achieve this, I'm using a counter (that...
Hi,
I connected MCUBoot and FOTA to my project. I checked that the download is working, but not stable. I saw in the documentation that you can enable the continuation of...
Hello I need a falling edge response via GPIOTE. The settings I use for sdk 16 to sdk 14.2.0 do not work. For sdk 16 I use the functions nrfx_gpiote _..., for sdk 14.2.0 nrf_drv_gpiote_...
I observed a peak of 334 ua during system-on low-power mode during idle time which is periodic around 4 sec. I am using ble with RC clock option.
1.is it waking for calibration...
Previously, I learned that BLE is capable of 1:1, 1:N, and N:N communication, but I didn't get the exact information. Can I get some information? How do you do it, what's...
