Software and Softdevice: SDK 12.3.0 keil5
Platform: Windows 10
Hardware: NRF52832 DK
I am trying to combine WDT and FATfs together. But once I have both of them, there...
I am trying to get a good handle on the difference in average power consumption between BLE point to point and Zigbee on an nRF52840. We have battery powered products and...
Hi, For my project, I need to design a BLE packet sniffer which scanning the 40 channels. Therefore, I need 40 dongles are connected to a computer that can read and transfer...
I am writing code to get a nrf52840 DK to associate with an existing 802.15.4 coordinator using the 802.15.4 API module within SDK 15.2.
I've called "mlme_scan_req" and...
Currently, I am able to use Mqtt Publisher or Subscriber with only one Nrf52 device. I can ping to the device with link-local address.
I am using Nrf52832 with SoftDevice...
Hi everyone,
After days of figuring out how CMake works, I try to write a CMakeList.txt myself, and decide to put my progress on this community. Right now, using CLion with...
i am using nrf 52832, i got SAADC example code from sdk. that code done by using timer. i could not understand timer section. Is available SAADC simple example code without...
There is a similar question here , but it uses a custom makefile which I am not familiar with. I am trying to convert a program I wrote using base TWI communication to use...
I had a custom BLE service working just fine, but once I tried to integrate buttonless DFU (based on the SDK example) I started getting the NRF_ERROR_NO_MEM error. I was able...
Hi. I am using three different device which can communicate with the nRF52840 through SPI.
I am using nRF52840 as master and the three device as slave. All the device will...
Hello,
This is regarding the problem faced while flash and debug the nrf9160 feather,
1) Build and flash using the west
we are using nrf 9160 feather so it has...
Hi
Is there a possibility to have an individual pinreset time? In my product the default reset time from 20ms is not enough.
Can you extend the command with a time parameter...
When I enable the OTA AT Command on the nRF52832 module and click on the DFU option available on the nRF toolbox Android Application, selected the OTA Package which shows...
Hello,
I am working with the nrf52840 chip and wanted to know if there are any pins that are shown on the schematic diagram, that I should not use to ensure that the Bluetooth...
I am working with nRFConnect and the nRF91-DK on MacOS Catalina.
After updating the command line tools I was able to program using the GUI
But now I want to write this...
I need to monitor how much heap was ever left available, as a minimum, after I have run my CI test suite. This is the true minimum heap ever remaining, so taking account of...
Hi -
In reading through the data sheets for the Nordic chips that support the low-rate (125 kbps) BT 5 PHY, I'm seeing Rx sensitivity numbers around -103 dBm. For the 1...
Hi,
To manufacturer production I would like to use the nrfjprog.dll in order to make an WPF C# application to program our NRF device.
I would like to use your nrfjprog...
Hello,
I am working with the nrf52832 chip and wanted to know if there are any pins that are shown on the schematic diagram, that I should not use to ensure that the Bluetooth...
