Hi.
I am using the NRF52 Development board, on Keil uVision, to implement a C program that uses Dynamic Structs. The Structs re-size themselves ( by increasing their capacity...
Hello,
I have an NRF51822 (redbealab ble nano) that I would like to use to count pulses in very low power mode.
Pulses are asynchronous
The rate of pulses can...
Hi
I'm attempting to read a PT-100 sensor value that is part of a voltage divider using a nRF52.
Both the reference resistor and the PT-100 is sampled while the voltage...
Hi
I have been searching the forums, but were not able to find an answer to my question.
I'm trying to sample 4 analog inputs on the nRF51-DK using the ADC hal. (SDK10...
Hi
I have been trying to get two NRF24L01 chips communicate with each other since a week now, without much success. All what I can find on the net is Arduino examples using...
Hi
I have done several projects with the nRF905. I know the device quite well. Normally I use the CD, AM and DR interrupt pins to determine the status of the device, my current...
i made this project to try to create RSC service on arduino
developer.bluetooth.org/.../runningspeedandcadence.zip
unfortunately the server starts but i'm not able to...
Hi,
I was performing a mesh DFU, using a nordic Demoboard with a serial mesh bootloader and starting DFU with nrfutil.
The DFU starts and works good (packages are sent...
I have a call to bt_scan_start after a device disconnects.
When the device connects again, I get this error:
ASSERTION FAIL [params->value] @ WEST_TOPDIR/zephyr/subsys...
I am using the nRF Connect 3.6.0 Bluetooth Low Energy app v2.4.2 on MacOS. When I pair and bond with my device it works fine. I can disconnect and connect in the same session...
Hi
I am using nrf9160 device and in my application and have to use mathematical logarithm function in my application.
Could you please help me how I can use mathematical...
Hi!
I am trying to test the CLI over BLE example. I want to use it in another application for logging data to a laptop console over BLE.
However, I am having trouble following...
Hi,
We are using NRF52832 MCU for one of our BLE based project.
We are running out of memory when specific operation performed. Buffer crashed.
What is minimum setting...
I was using log to print debugging information when the BLE_GATTS_CFG_ATTR_TAB_SIZE message popped up. It doesn't normally happen. What's the reason for that? Thank you very...
After flashing the nRF-9160-DK with the required firmware ( as instructed in this video https://www.youtube.com/watch?v=rMvW3HXLErk&feature=youtu.be ), the LED 3 is flashing...
Hello,
we need to disable UART0 to achieve low power operation of our device. This is done by running:
This works correctly on a minimal example when building using...
Hi ,
I want to know if it is possible to interface NFC text record example with ble_app_uart example. I want to run both the programs simultaneously. As the NFC text record...
Dear all,
The forum is full of questions around printing floating point numbers, however, I have a rather strange issue where maybe someone can help.
I have a project...
