Hi,
I'm programming the nRF51822 and save some user data into the FLASH by using pstorage_update . It works fine if I set system off mode, and wake it up. I can read back...
Hi,
I have been using nRF51822 with my Android app using Android's Bluetooth Low-Energy APIs.
In order to get more details, I am currently working on integrating the Android...
I'm looking at interfacing a typical Wheatstone bridge sensor to the nRF51822 ADC. This particular sensor only requires a mA or two for excitation and the output fits within...
When use the "nRFBeacons" app to update the info on my beacon the following happens:
Go to update tab.
Select "Connect"
Press "SW2" on beacon and see the LED begin flashing...
I am using s110 and nrf51822. I've set up up a long characteristic of 154 bytes.
Sending between 1 and 154 bytes works as expected.
Sending 155 - 160 bytes gets rejected...
Hi,
I tested the nrf beacon application, it allows only the beacons with company identifier 0x0059 (nordic's id). But i need to modify it to support all the device, how...
I use a app_timer_create() function to create a task(200ms once)
when in the task_timeout_handle() ,
I do something more than 200ms,
what will this timer going ?
Hi All,
i would like to know about
1) what is channel in nrf51288?
2) is there any mathematical relationship between channel no and pin no as in ble_app_hrs
example channel...
Hello,
We're looking for easy way to communicate between nRF51822 configured as central part with C# application.
Ideally we should use standard firmware which forwards...
Hi,
Im trying to monitor the high voltage im generating with PWN using ADC. I also need to run BLE at the same time to provide results.
So far I dont have any luck and...
Hi,
Why you use a Hex format file for the firmware with a Toolbox Android, then the IOS Loader you use a binary format file ?
Because I would like use the same file. ...
I have a nRF51822 and arduino uno board. Is it possible to connect my nRF51822 uart to the arduino rx/tx, so that i can use it for communication to PC through arduino. The...
I'm having some problems when flashing the mbed enabled nRF51 kit. This is currently my environment:
When I try to download the file I always get this error: "Cannot Load...
Hello all,
I have two services which has characteristics with indication only property. I am using sensor simulator to generate values. When i write first CCCD write of one...
Hello,
I have been searching for GPIO documentation, particularly on interrupt configuration, and I have come up short. Can someone send me a link where I can find more...
As we know, there is a solution of wireless charging in nordic. I just want to know where is the Bluetooth stack in the solution? In SOC or in Bluetooth controller? If In...
Hello,
I am using nordic development kit nrf51822 and i was trying some examples of it as given. But in that in one example there is one function
static void gpiote_init...
I am aware that the debugging interface draws significant current, I do not believe that is the case.
I have 2 designs in front of me. Let's call them '2.0' and '3.3' ...
Hi
I'm a little confused with the RAM usage with S110 support, the following represents the memory usage of example of "ble_app_template", even there is no any application...
Hi,
i want to know
how to sink mobile and softdevice in BLE or WIRELESS(having 4.0 stndrd)?
how to send BCON from nrf51288 board in order to set connection with...
