Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
We're seeing an issue where a dfu package containing SD+BL+Apps gets stuck on iOS nrfToolbox during DFU process after it updated the first part 1/2, which is BL+SD. The same...
Dear Nordic Team
I am developing a BLE device using the following resources:
- Microcontroller: nRF52832
- Softdevice s132
- Peer Manager is used for whitelist...
Hello,
I have developing one project in that i am using nRF52832 and SD 15.0. Here is the current application developing:
There are 3 ble app_blinky(ble peripheral)...
what do i need to modify in an application to send that application over mesh? Lets say i wan to send blinky example over mesh to all other nodes, what i need to change in...
I am using the mesh SDK 2.1.1 and have one node that uses the serial API. That node sends mesh packets to the network via the PacketSend serial opcode. This command uses an...
I am looking for resources/documentations about implementing subnets in Mesh. The use-case I want to implement is:
1. Create two subnets: Subnet A and Subnet B.
2. Provision...
i've seen examples in the nRF SDK using FreeRTOS and am very interested in integrating an (RT)OS for upcoming embedded projects since they very quickly outgrow the limits...
I'm evaluating the nRF52840 for a new project.
I have read a number of previous posts that show that I can't achieve what I want, but I want to be sure as the 840 is ideal...
Hi,
I'm using the nRF SDK for Mesh v2.1.1 with the Interactive PyACI Python console. I have been able to run the Interactive mesh provisioning and configuration example...
Hello, I am having trouble with output display on my nrf52840dk.
I tried resetting the device. It has no effect. I using RIOT OS to flash the board. PyTerm outputs nothing...
Hello, I've been evaluating the PDM hardware driver for the nRF52832, and the PCM output of Thingy. I've found that, for certain impulses at the input of the microphone, the...
Hi I have successfully set up my ARM SPI interface to use the nRF24 chip. At this time I'm trying to establish connection but I'm not sure I under stand the setup for comm...
I'm getting this when im trying to select the device.
when i try to update the firmware nrfgo studio is getting closed
please help me in solving this!!
Let's first compare two pieces code:
This one works:
But this one doesn't:
My problem is that as soon as I try to process received data, some of data is lost. Is...
I am developing with SDK 15.0.0
I want to add NUS service in ble_app_buttonless_dfu example.
All I have done:
1. Add including files and including paths to the project...
