At some point in the past I had nrf51+gdb+breakpoints working just fine. I even have a bunch of __BKPT() calls in my various error handlers to trap into the debugger.
At...
Hi,
I'm trying to program nRF51822 Beacon Kit using nRF51DK. I'm trying to load the example ble_app_beacon to the beacon kit. After uploading SoftDevice 7.1.0, I try to...
Hello
I'm using the nRF51 DK and I have a UART over BLE link set up between the board and a phone with the nRF UART app. I'm trying to get the board to execute a particular...
Hello there guys i been reading your 100 pg PDF for awhile now and im yet to understand or realize how is it that i add/place/create a payload or data to send/Tx via Master...
I am interested in writing a BLE central that reads data from multiple BLE Nordic sensors. The BLE central will be running on Embedded Linux which uses the BlueZ stack.
...
Hi,
I'm trying to get S110 softdevice (v8.0.0) working with RIOT. I had some issues (I couldn't initialize TIMER1 or TIMER2 until softdevice is setup & enabled) but I think...
Hello everyone,
I got a task which I try to implement using a NRF51822 iBeacon board.
The Task:
Advertise a Device and provide a mechanism to connect without traditional...
Hi,
I've install the throughput example (examples/ble_central_and_peripheral/experimental/ble_app_att_mtu_throughput) on an nRF52840-DK and I test it against all kind of...
I made 20 pieces of porototype devices. Testing some damaged them, NRF52832 does not work and the voltage on them is 1.556V, others work again but after disconnecting the...
Hello All,
I am trying to publish the data gathered from UART using MQTT . So far I was able to get serial data in the inData buffer. I am not able to publish data automatically...
To the kind attention of Nordic support team,
According to your valuable experience and manufacturers' capabilities, having the package a pitch of 0.35 mm is it possible...
I use nordic 52810.
I am trying to use s112 and HW IIC but I got the compiling error:
twi_hw_master.c:34:5: error: 'NRF_TWI1' undeclared (first use in this function) ...
I have a nRF52840 based product prototype which includes a power management integrated chip (PMIC) and a Li-Po battery.
The product recharges via a USB connector. The USB...
I am always getting the same issue on each sample I try to build. Not only on this "lte_lc.h". This error is also shown with several files or on the code lines....
Checking...
I am trying to “spy on” two ANT+ devices talking to each other:
The first device is a bike trainer running the ANT+ FEC profile
The second device is a computer (running...
I am using 52840 dongle, program using this: nrfjprog --reset --program _build/nrf52840_xxaa.hex --family NRF52 --sectoranduicrerase, but I got There is no debugger connected...
In the SDK example, it says:
Connect to the device from nRF Connect for Desktop (the device is advertising as 'Nordic_HRM'), then bond to the device.
However, I couldn...
