Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
Dear Nordic Team,
Thanks for supporting.
Anybody work with ultrasonic sensor (HC-04). Please guide me. I am just interface with arduino example its working good. It...
Hi all,
I'm completely new to wireless connectivity development and I am looking to use a nRF52832 module for simply communicating button presses between a power optimized...
Bought the Thingy:52. Works fine with its Android app.
However, was that the right decision to get started programming?
(I lost a weekend to find out that I cannot download...
Hello: I am using an NRF51 dongle. Date on the device sticker on the back is 2015.38. Also using nrf51_ble_driver_linux_0.5.0.
I can see/connect to the device I am trying...
Hi!
Thanks for this post blog and question on sniffer logs . However, I am not clear on how to calculate the number of packets sent every connection interval? Please clarify...
hi,
Is it possible to restrict range / rssi value upto certain range.?
I want to connect ble within 2 meter only. No device should connect after 2 meter.
kindly support...
Hi,
I am sending total of 1 MB data from central to peripheral device, both NRF-52, in one instance I have tried to change the connection interval i.e. for 7.5ms-> 192.624kbps...
I have worked on a new project which would convert our NRF51 project into NRF52. I have succeed in compiling and linking code for this new NRF52 project. When I start debugging...
Hello,
I'm trying to port an Eclipse project template that I have set up for the NRF52 using SDK 13. I want to downgrade the SDK to v12.3 in order to be able to use the...
Hi! For a custom board, I have my app working ok. So I wanted to add the dfu secure bootloader to my project. I Had no problem to do that, both app and bootloader start ok...
Hi
Why does making an input differential lose a bit on the nRF52. According to the data sheet, if a channel is 10 bit and using 0.6V reference and gain 1 and input is 100mV...
