I am using nrf sniffer for trouble shooting. But it always exit unexpectedly. Wireshark was still open but the DOS window got closed.
I am attaching the log.txt.
log...
Hi all,
I am using ble open mesh with pca10028 boards ble mesh is working fine.
I am developing a application that has to blink led in mesh( without any delay between...
I'm still on stack 8.0.0 so it might have been fixed since. I have noticed that if the other side de-asserts CTS the Nordic code will leave the TX asserted in a Break condition...
Hello,
I'd like to ask what is the data rate when using BLE OpenMesh network and how much it depends on network architecture.
I'm considering using it in a network consisting...
Hello Nordic Community,
I need to know how to import my PCB design from Eagle to CST Studio to simulate it and I need to know if the simulation step will be useful to enhance...
Hi.
I'm trying to get Apple notifications to nrf52. And specifically to listen both regular ANS (for android) and ANCS (for iOS) events depending what sort of phone is...
I am trying to find out the part number of the antenna (I assume it is a PCB antenna) used in the nRF51 DK ( www.nordicsemi.com/.../nRF51-DK) . I found a lot of similar questions...
Hi,
I am adapting the uart example to send mensages between central and peripheral using JSON. In this moment I can send central <------>peripheral...
I have a problem...
HI I'm developing Mesh network with SDK for mesh 1.0.1.0
I just started with own provisioner code bud a really need some debug print while programme running.
I tried a...
i have created whitelists for filtering connection its working fine now, but when i restart my firmware the stored whitlists data become cleared so i need to bond each time...
Hi All!
I use "examples\peripheral\usbd\" example Project as reference to implement my own HID protocol.
I use only EP1 in/out 64 bytes both.
faced with a question,...
Is it possible for a peripheral device to start a Bluetooth Low energy advertisement and then read the RSSI value in the advertisement packet that it sent once a connection...
Hello,
I have some trouble to use fstorage function with dfu function,
please help to let me know the solution in order to solve the following issues,
thankful for...
Hi,
I'm getting back "01 10 06" when attempting to send 0x01 Start DFU to the DFU Control Point from my gateway which is a Pi3 running Noble. Notifications are enabled....
Hello, i've read in the infocenter that there is/will be a new nRF52840-PDK Hardware (v0.11.x). Is it already available? If yes, who distributes it? If no, when will it be...
nRF52832 SDK 14.2
Hi.
I would like to know how I can run a function in the background? In my case, I want to process a queue in the background. Here is the scneario: ...
Hi all,
after call inside the BLE_GAP_EVT_LESC_DHKEY_REQUEST I got error 8, what can cause it? a CONNECTION_SUPERVISED_TIMEOUT?
device nRF52, SDK13
Thanks
Board: custom board; Mesh SDK: V1.0.0; Softdevice: S132_5.0.0; IDE: SEGGER Embedded; BLE: nrf52832
When I test the example “Interactive PyACI”, I need one node(A) send message...
I'm trying to connect with SPI interface. I've some little problems to understand about how technically do it,
I found this code on the web:
Just to understand how...
