Hi Nordic Team,
The atomic fifo implementation is based on armv7-M, right now I want to port it into cortex-A processor, I made some changes to get it compiled without...
Hi,
Kit:nrf5340
Can you please tell me if there is any example in nrf connect SDK v1.5.0 related to data transfer concepts.
Is ble controller will be enabled during...
I'm was testing the gsp sample in samples/nrf9160/gps. It runs fine on my nRF9160DK and reports NMEA messages. However, when i ran it on my custom board, it failed in setup_modem...
Hi,
I'm attempting to obtain sensor values for a project to be completed less than a week from now and I have not yet started programming so any help would be greatly appreciated...
Hi
I am using nrf52832,SDK version: SDK : RF5_SDK_17.0.2 .
USE CASE:We have two central and one peripheral.We need to control two central with one peripheral(REMOTE...
Hello,
I am facing an issue with SPI when the SoftDevice S132 is enabled and i cannot figure out what the problem is.
The following test works perfectly when SoftDevice...
Hi Guys,
I need to implement the Zigbee gateway function on nRF52840, I have download the Zigbee SDK from the Nordic website, but currently only have version 1.0, and I...
Hi,
I am trying to send accelerometer values through bluetooth for nRF52832 and SDK 14.2. I am using "nrf-mpu-simple" program form this ' GitHub ' repository and added BLE...
Hi,
I use EasyDMA with UART.
I'm in permanent reception and the received octects go directly into a memory buffer.
When the buffer is full, the writing starts again...
I have been using a JTAG to program a nrf52832 chip (SD v15) during development and am now testing firmware updates from iOS. As part of it, I've made a firmware package using...
Hi,
the default board of the homekit SDK is PCA10040.
I want to run ble_hk_doorlock_static demo on board PCA10056 , What changes should I need to do?
tool-chain :...
I am currently trying to minimize radio noise when collecting data via the ADC, on a custom board powered by a battery (when the radio fires, it introduces a lot of noise...
Hi team,
My customer wants to apply Serial DFU in their product, but when they are developing with SDK13, they find our release notes with:
** DFU ** - Added support...
Hi I'm porting an existing project from nrf51 to nrf52810 and trying to configure the UARTE EasyDMA to handle serial reception.
We have serial messages of variable length...
Hi DevZone,
Is there an example implementation in SDK15 using Crypto-Frontend and Soft-Device together? I have been trying for days to merge two examples (tried to import...
Please tell me the setting range of the following parameters
#define MIN_CONN_INTERVAL MSEC_TO_UNITS(20, UNIT_1_25_MS) /**< Minimum acceptable connection interval (20 ms...
Hi
I am running saadc battery measurement using the refernce code.
When I run the adc_configure() I have about 500uA consumption
then According to this thread I run...
Hi,
we are using BL600-SA in project,we want to configure ADC input Channel,In datasheet not able find the which channel number assigned to pins cleary,if we want to configure...
Hello everyone,
I'm facing difficulties trying to make SPI List work on the nRF52840. I'm using SPI1, clocked at 1M. START task is triggered via a GPIOTE event with PPI...
Hello,
I had a look at the brand new mesh 2.0 SDK, this looks very promising. I've been looking for some protocol description for the GATT connection to do the provisioning...
is there an expected release date for the soft device that supports the full bluetooth 5 specification including extended advertising beacons using a coded PHY with S=8(125...
