Hi.
I am using S130 softdevice version.
Basically, I am using NUS Service and make a my own NUS central service as NUS_C.
It is correctly work at normal state.
When...
Hi All,
Please Reviwe for a attached circuit file(Chip ANT of nRF51822.pdf).
I also attach a datasheet of chip antenna applied for that circuit(SDBTPTR3015 Data Sheet...
to me it made sense that EN_AA settings are controlling the receiving pipes if an ACK has to be sent back upon receiving a valid packet.
then i thought that the settings...
I am using BLE_Gateway example defined in nRF51-ble-bcast-mesh to create an rbc_mesh over 2 nRF51422 devices . For now, I am just testing it out on 2 nRF51422; I will set...
Hello,
I see when you import an example from the pack installer ( for example pwm, ble, timer examples ) it arrives with the misc controls --c99 on by default , so I cannot...
Hi,
We're looking for a low-latency 2.4GHz solution (not BLE) and the nRF51822 is oft-quoted as providing low latency, but what are the typical ms figures we could achieve...
Hi Community, many thanks for reading!
I have built a Breadboardadapter for an ISP1302
Inside
On Breadboard
There is no Groundplane or design rules.
Yes,...
I am using a nrf8001 and the arduino aci library ported to work with my project.
I have started from hello world example.
Connecting to the device from android app, sending...
Hi there.
I am compiling the Nordic MQTT subscriber example (using TLS), and see the following error:
c:\program files (x86)\gnu tools arm embedded\5.4 2016q2\arm...
I have an example app ble_app_cscs_pca10028_s110 and when I add /../../../components/drivers_nrf/nrf_soc_nosd to User Include Directories I get an error NRF_EVT_FLASH_OPERATION_SUCCESS...
So right now i have one characteristic which is writable and it has 8 different fields within it.
If I read it with nrf connect app i get 0B-00-0C-00-0D-00-0E-00-0F-00-10...
Hi all, I'm working on SDK12.1.0, soft device s130_nrf51_2.0.1_softdevice.hex. I need to two 128 bit services for these I increased the vs_uuid_count to 2 but it not advertsing...
Hi All,
Please, I would like to know why when using bootloader on nRF51822 , the app does not start when it is being flashed with a debugger (I'm using the J-Link), however...
Nrf_dfu_settings.c used 1.7k RAM in examples\ble_peripheral\experimental_ble_app_buttonless_dfu project ?can used more less?
Nrf_dfu_settings.c -> nrf_dfu_settings_write...
tr4x_87dB_0xc7_1024_7．5ms_おかしい.psd We are using a transmission scheme where we tag each of our packets with a block number and fire them off using write without acknowledgement...
Hello!
I tried to check the saadc value by using sample that is provided nordic homepage,
and I just found that the saadc values changed when I changed the compare time...
Dear All,
I see that there are many nrf52 modules available for shipping already. May I check with you, which one is the best interms of ease of development(HW/SW) and support...
I need to develop the IIC Slave function by using a GPIO of the nrf51822, but the development on the KEIL with C is not enough, GPIO with C program is too slow to follow the...
