Hello,
can the radio notification and radio disable APIs be used to use the radio hardware from the application layer?
Background of my question is, that I have an application...
Hi,
I am using central s120 with peripheral s110. The connection to the peripheral is depending on the name advertised by the peripheral.
When connection is done, the...
Hello,
I am trying to ecrypt some data in order to send some data encrypted in the MINOR and MAJOR adverts of the device.
I used this code to ecrypt the data ( this is...
Hi,
i use anRF51822 with soft device 7.
I run the UART app on my iPhone 4s with ios7 and on the nrf51822 board the ble_app_uart with keil uVision5.
Both devices connected...
Hello,
I upgraded nRFgo Studio software to version 1.17.0. Installation goes OK but the application crashes every time I try to launch it after installation process.. Then...
Hi,
i tried to send data from ios 7 via tx_characteristics(like in UART example) but received error:
didWriteValueForCharacteristic 2A38 error = Error Domain=CBErrorDomain...
I have been trying for a few days now to get my environment setup for development with the nRF51822. Since there is no official configuration for the Mac w/ Eclipse I have...
hi i have made gate opener for my farm, i am using MPU9250 and nrf52 to measure how much degree its open i am putting my MPU in cycle mode to wake up and take data, but it...
Hello
I would like to point out that I have no knowledge of electronics.
I am in the advanced stages of building a project on the basis of Adafruit feather nRF52832, The...
I am trying to test the fatfs example (SDK14) using the 10056 DK.
I do nothing modification and it results in...
<info> app: FATFS example started. <info> app: Initializing...
I realize I am like the hundredth person to have this problem but all the solutions I have found don't seem to work.
I am trying to add a simple header file to the nordic...
I am new to Nordic, I am able to compile and run examples on nRF52-DK.
I know there are examples are done for us but how I can develop my own project which use multiple...
I just replaced SDK 14.0 with the shiny new SDK 14.1 in my project. My project uses components from the SDK, but I don't use the exact same structure. Once again, it won't...
My Environment
Nrf52840
SDK : nrf51_15.0.0
soft device : s140
Target : Scanner (central)
I am trying to set GAP parameter for listening single channel that is...
i use sdk14.2 52832 i use uart
UART0_CONFIG_USE_EASY_DMA =1 consumption ~2.1mA
UART0_CONFIG_USE_EASY_DMA =0 consumption ~650uA
Is this a normal phenomenon, is it true...
Hi,
I have a Development and Evaluation board by Waveshare and i have a nRF51822 board. I have downloaded the nRFgo studio and i have used a USB to UART board and connected...
Hi
I am developing an application where nrf52 acts as a BLE central
Specifications requires that this node should connect to a peripheral with a specified name, obviously...
I have 2 services are running using 16 bit UUIDs and now I am adding another service using our_service.c and our_service.h files but my program is crashing and leading to...
Hi Everyone,
I want to use the QSPI protocol to write data into the external 64Mb of Flash memory provided onboard of nrf52840 PDK.
I am able to run the QSPI example alone...
