Hi: The device shows successful reconnection, but the mobile end is not connected.
And the connection information displayed on the device is (public), which is actually...
I am trying to measure the 300mA system current.
I cut off the system lane and connected Vin, Vout.
And when in ampere mode, the system is not turning ON.
(When I replaced...
Hi Nordic,
I have a custom board using a Raytac MDBT53 module with nRF5340. The board is designed for 3.3 V / LDO mode, but during bring-up I likely flashed firmware/configuration...
Hello Nordic support,
I am using two nRF54L15 devices with NCS v3.0.1 and ESB DPL at 1 Mbps. Auto ACK is enabled, the payload is 252 bytes, and the retransmit count is 9...
# SoftDevice Controller assert during DTM receiver test at dead/marginal RF link (nRF52833) ## Summary On an nRF52833, running the nRF Connect SDK Direct Test Mode (DTM) 2...
A customer implemented a nRF52840 (QIAA package) and says the output power is about 10dB lower than expected. Having done multiple nRF52 designs with good results, I reviewed...
While configuring a scene, the blind device is not visible in the scene settings screen, so it is not possible to set or save the blind position as part of the scene.
Steps...
Hi,
I just started with the nrf 51822 eval kit. I've used keil before and am using the evaluation version. The Blinky example compiles, uploads and can debug fine (step...
Hi everyone:
by default , when a port(Port0) setting to output mode.
when i want to read the port(Port0) ,
i will get the port Output state. but at the nRF51822(NRf6310...
I have the nrf51822 eval board and I am just trying to download the blinky project. I have followed the quick start instructions in the nrf51822 user guide but every time...
Hi
In Desktop 2 v1.0.4, did you consider the debounce as keyboard buttons were pressed or released?
How long is the debounce confirming time? Thanks.
Jeffery
Hi, my name is nils. I am trying to develop on the nrf51822 eval board. I use eclipse an gcc with the j-link under windows 7 to programm/compile/and flash. I got it to work...
Hello,
We are working in the field of Electric Bike Propulsion Systems.
We want our motor to be able to communicate to I-phone/Android phone on Bluetooth.
We are searching...
Hello Nordic experts,
I can find current consumption in standby mode data from nRF24L01plus datasheet.
But it seems standby mode current consumption is not mentioned in...
We would like to be able to communicate with an nRF51422 target system from a Windows host. (for target signal processing algorithm debugging ).
Our previous system used...
how can I program SPI to select more than only one slave device with any GPIO ?
SPI Routine "spi_master_int" can select SPI0 or SPI1 only with one dedicated GPIO as Slave...
I want to know the EXT interrupt (GPINT1 & GPINT0) can use at the same time. When I use the GPINT1 & GPINT0 at the same time,only one is OK the other is faile.
I'm looking at the led.c example in the heart rate monitor example. What this shows is how to tie a TIMER event to toggling an LED. I understand most of the mechanism there...
