Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
Hello everyone,
I am in trouble because of a vlotage of current problem, I think it is most a voltage problem.
Let me explain,
I have a NRF51DK that I programmed to...
Hi,
there is no migration guide available for 15.2 , my application currently uses 14.0.
1. when will the guide be available? can use the one for 15.0 till then? will...
I have followed this posting by Hung Bui , with light_switch_proxy_server being combined with the ble_uart.
I am using: nrf52 dk, Mesh SDKv2.0.1, nrf5_sdk_15.2.0.
By commenting...
Hi,
Errata 202 limits the use of vdd as a power source to external components and I, therefore, would like to use a GPIO instead.
My question: is there a need to use a...
Hi,
In my project I am using SDK 14.2 with S332.
I need to change the data in the manufacturer part of the advertisement packet once per second (nearly, timing is not...
Hi,
I have a strange issue. I am reading values from an accelerometer. The read values go into an array which is uint8 and 7 bytes long.
The values are read ok and they...
Hello everyone,
My usb connector is dead on my nrf51 dk, do you know if it is possible to program it without using the usb connector, maybe by using a USB serial port adapter...
Hi!
Does latest NRFUTIL 4.0.0 include mesh update option?
I saw in branch dfu_mesh on pc-nrfutil github that this branch was last updated on 16.12.2016 (nrfutil 0.3) and...
In my project LPN node need to communicate with more than one friend node.
Is it possible to make multiple friend establishments by single LPN node or is it something like...
Hi all,
I started a project on nRF52840 dongle with Segger IDE. I used SDK15.2 given by Nordic and my goal is to develop a program that permits to communicate between...
Hi,
Noted that nRF mesh app needs GATT bearer to provision a mesh device. I'm using 2 nRF52 DK boards, provisioning is fine, set the keys, subscription lists, etc, everything...
Hello, First of, I'm developing with eclipse an application based on the freertos example of the SDK 15.0 with softdevice S132 v6.0.0. My problem is that the nRF52 sometimes...
Hi. I have the latest topology monitor downloaded from the home page. It seems to have a problem. Every time i try to run it from my windows 10 machine (32 bit), it gives...
nRF TTM win32-x64 will not run on my PC. I use Windows 10 and am trying to run the executable but i keep getting "app cannot run on your PC. Contact the publisher....".
...
