Hello,
I'm working on a project using the nRF52840 and Zephyr, and I'm experiencing an issue when trying to use device power management (PM) with a custom sensor driver...
Hello,
I am new to nRF development. I am going through the nRF Connect SDK Fundamentals course.
I wanted to configure a GPIO on the nRF52833 DK board as an output and...
It seems that I'm getting different results reading QSPI flash from the APP vs MCUBOOT, with the exact same configuration. Writes appear to work fine from either, but MCUBOOT...
I am trying to get the wifi stack to connect to a wifi AP using WAP2 Enterprise (initially just with identity and eap_password, later with full ca_certificate check and client...
I've got some timing-issues with the nPM2100. As I could not locate the relevant information in the datasheet, I'm requesting this here.
My PCB has an nPM2100 with a mechanical...
Hi,
i acheived writting code that reconnects sequentially with multiple reflectors for my 1 initiator. When i am indoor i had good results, but yesterday i tried it with...
Hello
I'm using an external flash to store large files, but I’d also like to use the SMP service to exchange small files over BLE. For that reason, I want to create a LittleFS...
hi,
im a little lost with BLE at the moment. all i want to do is sending 3 bytes of data (sensor data) approximately 10 times (+- 5) a second (when the uC is not sleeping...
As a central, I am writing to a variable length characteristic, advertised by a service of my peripheral. In this case, I am sending 80 bytes of 0x01 as a test
uint8_t...
I used the ANCS program in sdk12.3.0, I have closed the white list function, I use the iphone connection and paired, then I ignore this device on the phone, and then I use...
Hi
I am using nrf51-dk board along with the S130. I am getting the following message when I debug my code. The central link count is set to 0 while peripheral link count...
Hello,
I didn't find much information about how different settings for the MTU size behaves with older versions of BLE devices. I'm using the softdevice s132 4.0.2.
...
When trying out the ble_app_hrs_freertos example in nRF5 SDK 11.0.0-2.alpha_bc3f6a0 , I seem to only get 14-character long device name announcements.
This happens when...
To @Hung Bui. Hello sir. I am new to NRF51 microcontrolers and I am trying to use Pstorage in my written code. I have noticed this post of your's:
I am using nrf51422...
Why do I call this bluetooth send function (ble_nus_string_send )return values is 04 not 00(return sd_ble_gatts_hvx), why will appear this kind of circumstance?When I send...
I am using nRF Connect with nRF52 and need to use UART over BLE to send command to the device but I find that you can only use hexadecimal input and get hexadecimal output...
I have nRF52 and working with SDK11.
I can start BLE advertising and nRF Connect app will detect everything correctly.
I only have an issue: I want to advertise for...
Hi there,
I am getting some error in my SAADC measurements and I believe it's due to the R_INPUT forming a parallel resistance with my voltage divider at the input (the...
Hi,
I am measuring the current during sleep, after the sequence, __WFE();__SEV();__WFE();.
With NRF_LOG_ENABLED set to 1, the current is about 486 uA. With NRF_LOG_ENABLED...
