At some point in the past I had nrf51+gdb+breakpoints working just fine. I even have a bunch of __BKPT() calls in my various error handlers to trap into the debugger.
At...
Hi,
I'm trying to program nRF51822 Beacon Kit using nRF51DK. I'm trying to load the example ble_app_beacon to the beacon kit. After uploading SoftDevice 7.1.0, I try to...
Hello
I'm using the nRF51 DK and I have a UART over BLE link set up between the board and a phone with the nRF UART app. I'm trying to get the board to execute a particular...
Hello there guys i been reading your 100 pg PDF for awhile now and im yet to understand or realize how is it that i add/place/create a payload or data to send/Tx via Master...
I am interested in writing a BLE central that reads data from multiple BLE Nordic sensors. The BLE central will be running on Embedded Linux which uses the BlueZ stack.
...
Hi,
I'm trying to get S110 softdevice (v8.0.0) working with RIOT. I had some issues (I couldn't initialize TIMER1 or TIMER2 until softdevice is setup & enabled) but I think...
Hello everyone,
I got a task which I try to implement using a NRF51822 iBeacon board.
The Task:
Advertise a Device and provide a mechanism to connect without traditional...
Hi Nordic,
I used FDS to operate updata to update data more than 10K once, but there was an error. Hint FDS_ERR_RECORD_TOO_LARGE.Can FDS operate more than 10K data at once...
I want to create own android app with just nus service (uart).I'm not very good in android programming, so there are two ways for me doing that:
Use Android-nRf-uart...
Hey guys,
I have another question related to this example.
I've modified the UART example such that UART printing is disabled, and I am calling ble_nus_send_string(...
SDK 11.0.0
SD s132 2.0.1
nRF 52 dev kit
I have been in the process of adding dfu functionality to an existing application.
Currently, I have gotten the dfu to work...
Hi. I'm looking for streaming solution.
I think BT5 will be one of the great solutions.
I refered video as below.
www.youtube.com/watch
It shows that nordic chip...
Hello All,
I am working on one of the project using nRF51822 . in this project it requires multi communication protocols i.e i want to configure as below,
2xI2C
2xUART...
I currently have 2 redbear nrf51822 nano. I want to connect the UART of the nrf51822 to my arduino uno/nano but i dont know how i should do this. I tried looking for a solution...
Hello,
I am using PCA10040 and sdk12.2.2. I am trying to load ble_app_template code. But when I try to flash my code in pca10040 I am getting error as "No Jlink Device found...
I have a nRF51-DK and SDK8+Keil5.
I also have a module that sadly uses an old revision 1 nrf51822. It is connected via SWD to my nRF51-DK.
I could programm it with keil...
