here I have a very strange problem. I m trying to send the data(1 byte) from slave to master,and I have to use the multilink demo because I will have 2 slave devices.
The...
I'd like to erase all the pages managed by FDS as part of a "Hard Reset" operation. fds.c has a hint of a "FRESH_INSTALL" directive (part of an enum defined in fds_internal_defs...
nrf51822
SDK v10
SD S110 v8
hello!
My pj is about ANCS+nus+hid mouse sevices.
If my borad had bonded with an iPhone,then download new hex from mdk ,and run.
...
Hello.
I would like to develop FW for the nRF52832, using Eclipse IDE + ARM GCC + Segger JLink OB.
I've seen on the segger webpage that the nRF52832 is a Cortex M4 processor...
When using app_timer through scheduler, a break and go will overflow the event queue if a timer is a repeat timer. The effect is that it's not possible to debug.
To work...
I need to be able to actively set the value being incremented in the Timer2 register on the nrf52 (what I believe would be it's main register). It seems that this might be...
The errata for the nRF52 indicates higher consumption in managing timers and GPIOTE. Does the BSP for SDK11 follow recommended practice to deal with these errata can I ask...
Theoretically, if I were to expose a GATT service to let a central write a 128 bit PIN to my characteristic, would I then be able to persist this PIN somewhere in the softdevice...
Hi,
I am developing firmware based on nRF51822 SDK for s110.
I would like to modify one or two bytes at Manufacturer Specific Data area in advertising data packet.
But...
Using nrf51822's PCA10001EK and trying the included s110 example called ibeacon. Keep hitting error 0x3001 which corresponds to "connection handle" error.
This error is...
I have not been able to make this app work. I programmed S120 as softdevice and loaded the application. Ran into problem with scatter file. I changed it based on the s120...
When sending data on a pipe with ACK (indicate), the acknowledgement seems to get lost if the device gets disconnected right after having sent that data. Is that a normal...
Hello,
I am trying to build a single device, lets say loaded with firmware "A".
I would like to have two of these devices, both with firmware "A" to detect proximity...
I can't find anything to indicate for sure that the S120 BLE softdevice will work on the nRF51422 BLE/ANT chip. I'm pitting BLE vs ANT for my current use case and being able...
nRf51422 flash data retention is 10 years at 40°C. We need for our application (motor control roller shutter) 20 years. What can you do to increase this value?
Hi All,
Please correct the following in my understanding. Also , i am planning to build a
remote controlled device using a PWM output. How does ATT,GATT and GAP affect/influence...
I recently purchased an nRF51822-mKIT and I'm having great difficulties in getting it to talk to either a Windows 7 or a Windows 8 desktop PC, or a Ubuntu linux desktop PC...
Hi.
I have just a question:
Can the same device work with gazell protocol and bluetooth LE alternatively?
I want a net with a host and some devices, but host must be...
I've somehow lost the ability to perform over the air DFU from Master Control Panel.
I have reinstalled the J-Link drivers, nrfgo studio, I've flashed the PCA10000. I can...
My board works most of the time are very good，but one time i power down the board when ble connecting and data transmitting，the board can't work when power on.and i can't...
