Hi,
I recently updated Nordic connect SDK and toolchain from v2.7.0 to v3.0.1. When compiling my application with activated CONFIG_BT_LL_SOFTDEVICE flag, I get this error...
Hello Team,
I am currently working with the nRF52832 and using the nRF Connect SDK ( NCS) with toolchain version 2.9.1. I would like to interface the nRF21540 RF Front-...
I don't have found CONFIG_OPENTHREAD_FTD feature in the bulb project prj.conf or prj_release.conf file, but I have found that it is enabled in the final .config file within...
I have installed nRf Connect for Desctop v5.1.0 on my windows 11 system.
I tried to update the Quick Start and install the Power Profiler.
Both gave me a similar error...
Hey All! I've been following the nRF Connect SDK Intermediate course from DevAcademy. In exercise 2 of lesson 9, bootloaders, you get to learn how to use KMU (Hardware Key...
Hi,
Testing Hardware: nrf52832 Module in a Custom board OR nrf52DK possbile -> We would like to change the order of the BLE service as shown in this thread: https://devzone...
Hello, I am trying to use the nrfx driver example to run an RGB led connected externally to the nrf5340 board. I dont see the led/pwm cycle running successfully. Can anyone...
I'm attempting to load the ant-fs reference design to two different nrf51422 evaluation boards. The application builds successfully but I am having difficulties loading it...
Hi
my application is a 9-axis battery driven motion sensor with a data rate about 144 bit per packet at 1000Hz i have to transmit over air. Low latency (<10ms) is extremely...
Hi,
is there any Example to use the UART ?
I need an monitor while the application is running, is the UART COM Port the right one for this?
Is there an example with...
I need a mutex and I found this information at the ARM site: infocenter.arm.com/.../index.jsp
Is there anything I should be aware of in using this technique to implement...
I have a central device , that acting as a gatt server. the service is customize, and 128bit- primary serivice UUID ,its characteristics' UUIDs(128bit) are all known, how...
How are the four RAM banks divided up in the nRF51822? Is it an even split of the 16K total RAM (i.e. 4K per block)?
Furthermore, can I expect strange results if I turn...
Hello, sirs.
My question is how to configure clock in gazell protocol on nRF51822
I look at the example gzp_dynamic_pairing but that does not have a code part of modifying...
I want to stream data continuously from a sensor to a host, using BLE.
Using the nRF8001, I have defined a GATT server, with notification.
From an Android phone, I open...
Can the nRF51822 handle more than one connection at a time? I suspect that the answer 'no' based on some indicators, but it'd be good for me to get a conclusive answer. Thanks...
Hi,
i need to handle a button detection Time, i mean when i push the button for 2 seconds something should happen. How can i use the app_timer_cnt_diff_compute function...
Hi,
I have been experimenting with the master emulator .dll - I started with the HidDemo project which is written in C#. This seems to work perfectly well.
I have rewritten...
