Hello：
Why Bluetooth Go to system-off mode, sd_power_ramon_set can not be stored. In D: \ RAM save nrf51_sdk_v5_2_0_39364 \ nrf51822 \ Board \ nrf6310 \ s110 \ ble_app_rscs...
Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
Dear Nordic Team,
I am using nRF51422 development kit.
I tried Beacon app example code.It consume around 195uA. How to reduce the power consumption.
I am also checked...
hi, I'am working in a project. I start a watch dog in that project,but I need to stop the watch dog something.And I don't know how to stop, can anybody help me.
nRF51822 and a PC were connected, nRFgoStudio was started and nRF5x Programming of a device manager was opened, the following comment comes out, and nRF51822 device can't...
hi i am trying to send data through external bluetooth using uart. however i am facing some issues.
The problem is that when connecting the tx pin from nrf52 dk to rx pin...
HELP ME! THX!!
Using the NRF51822, S110.V6.0, When I use the timer2 , want 3s timer of uart-sending words in BLE, but the result is not the same of the UART-ASSISSTANCE's...
Hi,
Edited topic to match the issue:
I've just started poking around with nrf52 chip and I'm now in process of waking up custom hardware, but I seem to have issue with...
Hi all,
I want to update my connection parameter as follow because I want to connect with both apple and windows devices.
By sniffing in Wireshark I found that my IPad...
I am using a static passkey to set up pairing and after that the devices are supposed to bond. The issue I am encountering is that when the wrong passkey is entered or if...
Hello every one,
i want to make a project including a ble chip, i decided to choose one the nrf51 or nrf52 serie, but i am totally unfamiliar with everything!
i have found...
Hello,
I played around with the UART demo on the nRF52-DK and the belonging Android apps nRF UART v2.0, nRF Connect and nRF Toolbox. On PC side I used a serial console...
I am trying the ANT-OTA DFU Update using an ANT Stick and the nr51422 pca 10028 boarde and s210 soft device. My firmware makes use of sd_power_system_off(). If I have an update...
Hi guys
I'm trying to load the ble_app_beacon project on a custom board. I am able to flash the softdevice and the application, but the chip is not advertising. So, I started...
I've got the experimental ble blinky example project on an NRF52 PCA10040 working fine with an added custom characteristic. I can connect, discover and read/write characteristics...
Hi
I've implemented support for the FStorage and the FDS in our application. In some cases it happens, that the function "fds_stat" does not return.
The reason can be...
