Hi I'm testing the current consumption of the external qspi-flash on nrf5340dk [ MX25R6435F]. I have used ppk 2 to measure consumption with the dk and also have used a power...
Hi,
We are using nrf21540 in GPIO mode + mode pin ( and CONFIG_MPSL_FEM_NRF21540_RUNTIME_PA_GAIN_CONTROL) with an nrf52833.
We are developing under nrf connect sdk 3.0...
During the development of a Matter over Thread product, I encountered the following issue:
After adding two Matter over Thread devices (an OnOff Switch and an OnOff Light...
Hi Nordic Teams :
I would like to check the current consumption by BLE DTM.
1. Is the table measurement is from 3.0V input?
2. I find the condition in the datasheet...
HI ALL,
nrf54l15dk,v2.8.0,peripheral_uart demo and no changes have been made.
Then add the following content to prj.conf
sysbuild.conf
mcuboot.conf
At this...
I'm developing my application with nrf 52832 and nrf SDK v17.
I know NCS is more powerful. I'm currently learning how to use it.
But now.I still need my application with...
I'm writing a wav file from the nrf52840 board to the nor flash w25q128jv with a capacity of 16mb but it seems that I can only operate on the first 2mb, even when dividing...
I followed a couple guides and set up my programming environment for the nrf51 dongle but having some issues compiling even the blinky example program.
I am currently using...
I would like to know, if it is possible to use flowcode for nordic chips development?
Yesterday I purchased the software development tool Flowcode. There is a complete...
I am new to PCB and embedded devices in general, but I have decided to try to learn :)
I have started looking at parts for my PCB design and wanted to use nRF51822-QFAA...
Dear Nordic developers,
I'm developing multiprotocol application by combining BLE and a proprietary protocol by using timeslots. In my project I need to disable BLE for...
Hi Nordics!
I am trying to merge my hex files.
I followed this post.
devzone.nordicsemi.com/.../
First, I made a .bat file in the \bin folder.
merge_test.bat...
Hi,
i have a bunch of nrf51822 hwid 0024 or 001E.
With softdevice s110 version 7 everything worked fine, but starting with 8, they pretend to work fine (no error codes...
Using the pure-gcc makefiles, at present I only see this for a stack trace in the command line gdb client:
(gdb) bt
#0 0xfffffffe in ?? ()
#1 <signal handler called>...
If you have the most trivial main.c possible, with a main() which does nothing at all, compile, link and load it at 0x00000000, it runs fine and does nothing .. that's basically...
I have a nRF51822 program in which a button triggered event doesn't work as expected and crashes the program. The program may have potential race condition problem. Here is...
Hello,
I've overcome most of my problems using this wonderful Q&A system from other people. Recently I've moved from a nRF8001 + MCU to a nRF51
Using SDK 8.1.1, keil...
Hi all-
I apologize in advance for the noob question but I have spent loads of time on this and can't make progress. I am trying to work my way through the nrf51822 User...
I want to experiment with recording observations of the beacons with raspberry pi's.
Is there any precompiled firmware I can install on the nRF51822 smart beacon...
Is it possible to add a payload (1-2 bytes) to the beacon advertising packet?
I intend place an ADC output to the payload. For now, I'm using nRF51-DK but later wants to...
