nRF52840 NCS 3.0.1 RCP
I just installed the NCS 3.0.1 SDK. I am trying to set up a border router on a Raspberry Pi 4.
I followed these instructions on the Raspberry Pi...
Hello,
I have a legacy project that is using nrf5 sdk v17.0.2. I need to add the BLE DFU functionality to this project based on the nRF52840. Are there any examples on...
We are trying to evaluate nrf9151 for working with Soft-SIM. Are there any instructions for configuring the Soft-SIM through AT command mode, or do I need to use another mode...
I was doing some developement for a custom board on NCS v2.9.1 when i noticed some of the changes i was making in my prj.conf weren't being set in the application. My impression...
In my circuit I have a MOSFET which disconnects the battery. There is a GPIO pin which turns this device on and I'm using regulator-fixed to drive it during start-up. A short...
We are currently using ncs 2.9.0 on an nRF5340. We use the BT_HCI_OP_VS_READ_VERSION_INFO to determine at runtime what version of the BLE stack is present. This information...
Is it possible to have discontiguous Non-Secure areas in SRAM to be used by the application?
&sram0 {
reg = <0x20000000 DT_SIZE_K(8)>;
};
&sram0_ns {
reg = <0x20002000...
Hi There
Here we have been encountering some problems and would appreciate if you could help.
We are designing the hardware based on the following schematic, please...
Hi!
Just want to ask if anyone have had the same issue as me, when flashing nRF9160 with J-Link V6.50.
In SEGGER Embedded Studio - Build -> Build and run || Target ->...
Hello!
I use a usb secure bootloader with MBR (without SD) for update my application via USB. Also, my application receives new firmware via GSM modem and saves it to an...
I'm using pc-ble-driver to talk to the nRF52840 dev-dongle from a Windows PC. I started with examples\heart_rate_collector\main.c I receive events in a function 'ble_evt_dispatch...
Hi all,
I want to use the nrf51dk to answer and reject phone calls. One button on the kit would be used to accept calls and another to reject or finish them. The audio...
Hi dear team,
I am using the nRF5840 Dongle and pc-ble-driver-py for development, but I encountered a lot of issue while debugging, I thought I used wrong parameter or other...
We have worked through getting AWS MQTT working and have the FOTA job file loading properly. When the HTTP request is made the file begins downloading but fails to download...
Hello, How do I program the NRF52840 module to read and write data with a single UUID, because the mobile application I used earlier was working with the data read and write...
Hi Nordic
I am trying to run the AWS BLE FreeRTOS demo found at:
https://docs.aws.amazon.com/freertos/latest/userguide/ble-demo.html#ble-demo-mqtt
I am using an...
Hi,
I am developing a product with battery power. To preserve the battery life, this product needs to work in low power mode.
My Environment is a nRF52832, SDK15.2 & custom...
Here S332 -ble_ant_app_hrm file is modified using supported board pca10040 (nrf52832).
There is in pca10040.h file,RX pin number & TX pin number predefined.
And we use...
Hello,
until now, I was using nrfjprog to flash devices. Command I used:
Now I have changed the platform, and am forced to use ARM processor. I found out there is a...
