Hi there,
I have recently upgraded my software to latest ncs 3.2.0. I have noticed that my initialisation does complete but it ends up with fatal error that seems to be...
Dear Nordic,
I am debugging a custom hardware with a nRF7002 on-board, using wifi shell app. At this moment the shell does not work as expected, needs to locate where the...
I am attempting to install nRF Connect SDK along with VS Code on an offline machine for development. The main two issues I have are:
The NRF Connect for VS Code plugin...
Hi
I am using the nRF54L15 DK and build a thread continueing monitor the data rate in 1 Hz, if it is lower to 800kbps I want to change to 1M; while above 800kbps I want...
Hi all,
I’m Bruce — first-time poster but have been working with the nRF9160 on and off for a while now, mainly in outdoor, power-constrained telemetry and monitoring applications...
I have a simple GATT server application with two characteristics, RX and TX. In my prj.conf, I am trying to disable pairing as follows :
I can connect to the server from...
Hello,
I am trying to use LTE connectivity on a custom board with a nRF9160 SICA B1, but i am facing issues with the modem.
With both my own app firmware and the sample...
Hello,
I understand reading your documentation that the nrf5x series have support for RPL but i can't find the implementation in the SDK 15.3.0.
Is RPL implemented in...
I am working on a project to do serial uart dfu in nrf52810. For that purpose i will be writing c code equivalent to nrfutil. I was going through all documentation and tried...
Hi, guys. I'm using PCA10056 and SDK 15.3's BLE UART peripheral example.
I also have a Microsoft HoloLens (the first version which runs Windows 10 and the HoloLens shell...
Hello
I am working with LIS2Dh12 accelerometer sensor interfaced with SPI 2 of nrf52832. For its one of the axis we have configured the interrupt which is working fine individually...
hi,i am using nrf52 DK kit. i have interfaced it with bmd 101 ecg sensor. The sensor sends continuous data over UART. I am using SEGGER IDE. The code which i am using is ble_app_uart...
Hi there,
I'm confused with the meaning of the 'vloc' variable in the attribute meta data. In the example code ble_bps.c of "ble_app_bps_pca10040_s132" , in the function...
Hello,
We are experiencing an issue that some of the nRF52832 is not starting up automatically. But we attached it with JLINK debugger and didn't do anything, it can boot...
Dear Community,
I'm including a wireless bootloader to enable firmware updates in my application. My question is the following:
Before entering in DFU mode from my app...
Hi,
I am currently facing a coming issue by using the function net_pton. Under MacOS I get the following error:
1> app/libapp.a(main.c.obj): In function `inet_pton'...
I've got this logs while running out of the box the light switch example in zigbee sdk v3.1. I am connecting to a smarthings hub.
<warning> app: Production config is not...
I'm attempting to write a plugin/dll to pull data from the Nordic Thingy52. I can scan all devices that are paired with windows 10, and load up the services, etc.
I can...
Hi,
I am trying to replicate the benchmark numbers stated by Nordic for the nRF52840 to verify I have setup the chip correctly for maximum performance. I have caching turned...
Hi everyone,
I try to send my nRF52 DK board to an android application.
nRF52 example source is "ble_app_blinky_pca10040_s132" and Android app sample is nRF-Blinky from...
