Hi,
I am currently testing the dect_shell example on two nRF9151 DKs and achieved a range of ~500m. I want to transition this setup into a multi-hop mesh network topology...
Hi: The device shows successful reconnection, but the mobile end is not connected.
And the connection information displayed on the device is (public), which is actually...
I am trying to measure the 300mA system current.
I cut off the system lane and connected Vin, Vout.
And when in ampere mode, the system is not turning ON.
(When I replaced...
Hi Nordic,
I have a custom board using a Raytac MDBT53 module with nRF5340. The board is designed for 3.3 V / LDO mode, but during bring-up I likely flashed firmware/configuration...
Hello Nordic support,
I am using two nRF54L15 devices with NCS v3.0.1 and ESB DPL at 1 Mbps. Auto ACK is enabled, the payload is 252 bytes, and the retransmit count is 9...
# SoftDevice Controller assert during DTM receiver test at dead/marginal RF link (nRF52833) ## Summary On an nRF52833, running the nRF Connect SDK Direct Test Mode (DTM) 2...
A customer implemented a nRF52840 (QIAA package) and says the output power is about 10dB lower than expected. Having done multiple nRF52 designs with good results, I reviewed...
Hi - I'm trying to use the pure-gcc make files and I've got my project building and the code is running, but when I try to launch startdebug gdb it reports no debugging symbols...
Hi
I cannot find the answers from your documents. Please help me answer them. Thanks.
DC supply voltage of core cell of nRF51822 chip?
DC supply voltage of IO pad...
I am using a modified sample of your rangedemo example and can get it to work. To test if I am switching to 915MHz I change the HFREQ to 1 but the receiver that is set to...
Hello
Im starting a new project and i wanted to save time by asking if there is a list of providers or company that produces sensors that will have an easy compatibility...
Hi,
I need to store an image of size 40kB to internal flash memory. Actually i tried to store it from the address like 0x28400 and 0x2E984 (memory addresses after softdevice...
Hi, I am developing an BLE application using nRF51822.
This question is from my previous question:
devzone.nordicsemi.com/.../question-about-adc-power-consumption
...
i have purchased one of the modules. i need to interface with other modules of the same kind but how will i start programming it ,can u people suggest me the IDE ? do i need...
Hi,
I try to modify 51822 device_firmware_updates code for 51422.
But I have a problem.
When I run my code, my cell phone can connect to 51422. I can click DFU button...
According to Page5 of nWP-018, if we compare QFAA G0 to C0, G0 doesn't have a valid version reference design with the right balun. But G0 and C0 have the same valid reference...
Hi there,
We're looking to use the entire 16 KB of RAM on the nRF51822 when the S110 is disabled. We've come across an odd case, where doing this:
memset(0x20000004...
Hi there,
I am trying to learn how to develop for the 8001 chip on an Arduino board.
Does anyone know a good tutorial I can use to get to grips with how i would go about...
I have nRF 8001 BLE chip.First i want to know will this chip contains any Firmware i.e it has its services and characteristic or not? And i want to write my own Services and...
Dear Sir,
I used nRF51822, I found sometime the program reset itselft. Then I made a test program to send out the "RESET REASON"by BLE message. I found the reset reason...
