Hello,
I have tried twice to request for SUPL license for getting A-GPS working but it has been denied both of the times. I think first time it got denied due to mismatch...
Hi Nordic Team,
The atomic fifo implementation is based on armv7-M, right now I want to port it into cortex-A processor, I made some changes to get it compiled without...
Hi,
Kit:nrf5340
Can you please tell me if there is any example in nrf connect SDK v1.5.0 related to data transfer concepts.
Is ble controller will be enabled during...
I'm was testing the gsp sample in samples/nrf9160/gps. It runs fine on my nRF9160DK and reports NMEA messages. However, when i ran it on my custom board, it failed in setup_modem...
Hi,
I'm attempting to obtain sensor values for a project to be completed less than a week from now and I have not yet started programming so any help would be greatly appreciated...
Hi
I am using nrf52832,SDK version: SDK : RF5_SDK_17.0.2 .
USE CASE:We have two central and one peripheral.We need to control two central with one peripheral(REMOTE...
I am unable to build my application for the Thingy:52 to perform FOTA over BLE. I have configured everything as outlined in the Nordic Developer Academy. FOTA over Bluetooth...
In my application I want to know if a DFU was executed successful and I'm using GPREGRET2 for it.
If a DFU as successful I'm writing GPREGRET2:
nrf_power_gpregret2_set...
Hi There,
I am trying to build a sample application (GNSS) on VS Code for my nRF9160 DK. The build used to be successful, but I noticed that it fails with the following...
Hello,
i am trying to install nRF Command-Line tools in my environment on my company's PC, i am on Windows 11 Enterprise on a Dell Precision 5820 Tower, and I am following...
I am unable to build my application for the Thingy:52 to perform FOTA over BLE. I have configured everything as outlined in the Nordic Developer Academy. FOTA over Bluetooth...
There is a lack of guidance on Blob Transfer Server/Client, so I decided to create and contribute a sample.
In Case ID: 331920, had the idea to add a BLOB Server and Client...
Hello Team,
We wanted to use a NOR Flash GD25Q32E to replace MX25R6435F which is using on the development kit. But we got an error. Please see below screen captures. ...
We are getting below error when flashing hex file in our custom board using a programmer tool but not getting the error when flashing using visual studio flash. 2024-10-15...
Hai,
We are planning to develop a Bluetooth gateway based on nrf52840.
the nrf is connected to esp32 through uart.
The duty of the nrf52840 is
1. It should receive...
Hi,
I'm using nRF Connect SDK v2.7.0 (this error happens with v2.5.0 as well). I'm trying to build the USB Mass Storage sample for FAT FS on flash, in zephyr/samples/subsys...
Hi,
I am writing to a characteristic, and I have noticed that the data is being truncated.
After establishing the connection, I performed an MTU exchange, and the MTU...
Hi
We are working on building a custom board for the nrf9161 as it's the newer chip but are having issues writing the IMEI to the device. I have flashed a modified version...
Greetings,
I have been trying to integrate file system into Winbond W25Q02 NOR storage, Initially I tested the hardware by interfacing SPI communication between nrf 5340...
Hello,
I am looking for some guidance in getting my application in a low power state. I originally came across the post here . I could not get this example working, and...
