Hi all,
I'm working with the nrf51422 and the nrf51822 and I was wondering what the current status of the over the air DFU system is.
I'm using SDK 6.0 and I managed...
nRF24l01+ at a transmitter module one time successful transmission show & after 1 sec failed also . if any doing programming with atmega32 ,please send code for TX & RX ....
Hello,
can the radio notification and radio disable APIs be used to use the radio hardware from the application layer?
Background of my question is, that I have an application...
Hi,
I am using central s120 with peripheral s110. The connection to the peripheral is depending on the name advertised by the peripheral.
When connection is done, the...
Hello,
I am trying to ecrypt some data in order to send some data encrypted in the MINOR and MAJOR adverts of the device.
I used this code to ecrypt the data ( this is...
Hi,
i use anRF51822 with soft device 7.
I run the UART app on my iPhone 4s with ios7 and on the nrf51822 board the ble_app_uart with keil uVision5.
Both devices connected...
Hello,
I upgraded nRFgo Studio software to version 1.17.0. Installation goes OK but the application crashes every time I try to launch it after installation process.. Then...
Hi ...
i want to change the device name dynamically, i read my questions related to it , still not working . Here , gap_param_init i have set the flag to change the device...
To the kind attention of Nordic support team,
I have got a
1. PCA10040 board, with ble secured bootloader installed
2. PCA10056 that I usually work with every day, these...
Hi,
I'm using direct advertising in order to connect to mobile devices which were already connected to my nrf device. After the first connection, I save the mobile address...
Could it possible to reduce INIT and ADVERISE times ?
What is normal startup time for nrf52832 init peripheral for advertising?
What is the minimum possible advertising...
In the OPS register description, as well as in the files modules/hal/nordic/nrfx/mdk/nrf5340_application.h and nrf5340_network.h the HFCLKAUDIOALWAYSRUN register is incorrectly...
Hi Guys,
I'm looking for some information on how to get data from the secure side to the non-secure side of the firmware. We are building an NB-IoT GPS tracker which is...
Hi,
Is it possible to change the security option of characteristic read or write?
For example , we initial the characteristic as JUST_WORK? Then change it to SEC_OPEN...
I have adapted the " nrf52-mpu-easydma-using-timers-and-drivers " project from Github that I saw referenced in another post and have successfully modified it to work with...
Hi, We are using the heart rate example for developing our firmware, where we plan to send data out every 15 mins. But when we try to increase the advertisement interval beyond...
Hello Nordic Team,
Currently i'm trying to join my custom HID (a joystick) with the ble_app_hrs_rscs_relay example (SDK 16) for a personal project which consist in: a nrf52832...
Dear Nordic,
I am trying to create a simple interface between my PC with Windows and using PyUSB (since it is a simple wrapper, using libUSB as backend) and the nRF52840...
Hello,
We have an old working product which is developed in nRF5 SDK v11.0.0. We want to add nfc type 4 tag part in our product.
In SDK 11 there is only support for nfc...
I am looking to understand the state of a pin after calling nrfx_saadc_channel_uninit(channel);
Does it simply return to the last configuration state of the GPIO or something...
Hello, I am using a nRF51822 chip to communicate with a sensor. The sensor continuously outputs its reading via UART every couple of seconds. This is what I am currently doing...
