Hi,
I am using a custom pcb with a nRF51422 chip, and trying to setup ANT communication between 2 modules, but the sd_ant_channel_id_set call returns an invalid address...
Hi,
To use bidirectional continuous scanning mode in ANT, I have to transmit Extended Broadcast/Acknowledged/Burst messages using ANT Msgs 0x5D, 0x5E, and 0x5F (ANT Message...
We are preparing to get BT qualification for our product, developed with the 6 stack now, however want to update to 7 when it is finally released. A comment from the testing...
What is the best way to minimize transfer in progress errors when trying to send ANT messages? I am using the S310 stack on an nRF51422. I have a busy ANT channel that is...
I'm running into a weird timing issue with a nRF24L01+ which I'm not quite sure how to work around in the general case. The basic setup is two radios, A and B. Auto acknowledgement...
I am using mbed library to get leg up on development.
This is the first time I am writing any MCU application and it sure makes things a lot easier.
I am using nRF51822...
I've recently began experimenting with the HID service and connecting to iOS devices in order to achieve lower connection intervals with Apple products (as described in their...
I'm trying to optimize an Azure project based on the Asset Tracker example. I was recommended setting CONFIG_SERIAL=n in both the Application FW and SPM. However when I add...
Hi,
I based a new device design on the Thingy91 antenna and tuning circuitry and noticing that the current consumption of the two QM12038's negates the amazing power efficiency...
1.In docs I see: “This example requires one of the following SoftDevices: S112, S132, S140”. What is the reason not to support S113?
2.Is there a way to accomplish functionality...
The Cloud_client sample application does not work in this version.
The connection with the nRF Cloud is disconnected immediately:
I: Network registration status: Connected...
Hi, I am trying to add a secure button less OTA service in my application.
1-I have successfully added service but showing the following error.(I can see OTA service in...
Hi,
We have been working with a Zigbee coordinator based on nRF52840 with nRF5_SDK_for_Thread_and_Zigbee_v4.0.0_dc7186b, Softdevice and FreeRTOS.
Zigbee task defines a...
Hi,
Is it possible to add a custom characteristic to a standard BLE service? I wish to add a CO monitor with ESS (0x 181A ). If yes, how to add a 128 bit UUID with this...
Hello,
I want to output in one pin 400kHz and inverse of 400kHz in the other pin. I have somehow managed to output the the 400kHz but haven't managed to output its inverse...
I'm trying to implement advertising only on a single channel
Here is my initiation function
but ble_advertising_init is returning err_code 0x00000006
I believe it...
Hi everyone,
I have come across the FPU_FFT example project for nRF52840. Just for curiosity - I'm HW-guy - I'd like to evaluate FPU's performance - to see how many instructions...
Hi,all:
since I add USBD in ESB example,when compiling and linking,I make error as nfr_queue dose not fit UNPLACE_SECTION, overflow 20 bytes. I take the line statement about...
I have a requirement to collect data over a plant, say a power plant whose size may be 3 KM by 3KM. I am planning to have a Bluetooth mesh and collect data and control equipments...
Hi,
We currently have a regular SIM, and it works well except for the inability have very low power draw when the device is in low power states. Based on our testing, we...
