Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
SDK: nRF5SDK Toolchain: ARM GCC
Hello,
I have some devices out in the field using nRF52840s, using the non-SoftDevice bootloader, and a custom mechanism for reading updates...
While the nRF5 SDK offers great support for validating the SoftDevice and application firmware in internal NOR Flash on every boot, it looks like that's not the case for the...
I am using nrf52 DK board with SDK15.3.0 developing my application on top of ble_blinky_peripheral example .
How do add CTS service in my application ??
I have refered...
Hi
I want to make use of this SD-card reader together with the nRF9160dk.
From what I understand:
1. I need to create a nrf160dk_nrf9160ns.overlay file to chose which...
Hi,
As in the subject, I cannot find where to change the optimisation level. I am working with the Zephyr bluetooth sample project - peripheral_hr.
I have found a previous...
Hi
I have register the esim of iBasis and its works relly well but I need know how to use a esim of a different company on nRF9160DK, I don't know if the location is important...
Hello,
I'm using a modified version of the examples->peripheral->radio examples from nRF5 SDK v17.0.0 to receive packets sent on Bluetooth Low Energy channel 37 using...
I use ble_app_uart_c.
I have a central(nRF52DK). I have a peripheral(nRF52DK). When i run my code, I would like to see my peripheral's name and it's UUID on the terminal...
I am using SDK 16.0.0, Soft Device S132 (v7.0.1) on a custom nRF52832 board.
I have a secure boot loader on board that is triggered by a buttonless OTA application.
After...
Hello. I'm in the midst of purchasing a power profiler to works with nRF51 Development kit and nRF51 USB Development Dongle. May I know if all the technical resources on nRF6707...
Hi there!
I am using the bluetooth/peripheral_hr sample as a basis for my application, on top of which I need to include the nrfx_qspi driver. However, I get a "undefined...
I wasted a day with this issue. I could not understand why app_timer_cnt_get() was giving me garbage on the nRF51 DK when running normally but when stepping through the debugger...
Hi, all.
I would like to assign location address for some global buffers or variables in ram by using __attribute__ keyword. And I have to add my section in flash_placement...
Hi,
I want to send data in JSON format to android app. I used ble_app_template and midi_service template to create my own service. I can send data binary as much as I...
