Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
Hello,
We have experienced odd problem, we are not able to scroll up or down SDK documentation at these pages on Android devices. IPHONE browser Safari works ok. Any help...
Hi ,
1-) Is there any dma half transfer interrupt ? if there is where it is in documents ? ( i check this link but i couldnt see anything about this https://infocenter.nordicsemi...
It is pretty straight-forward to use J-Link RTT Viewer on Windows (as described in the Debugging with Real Time Terminal tutorial ). Is there a similar viewer to use with...
Hi,
I am designing a bio-signal measurement circuit using nrf52832.
I wonder if there is any problem with the performance of nrf52 when using the sensor below.
Sensor1...
I can't comment in https://devzone.nordicsemi.com/f/nordic-q-a/56685/missing-ble_gatts_evt_hvn_tx_complete-events as it is closed but I am also seeing issues with the TX_COMPLETE...
Could you display on the ticket list page also when the ticket was last updated?
Now it shows only creation date, but I do not see indication which one was recently updated...
how can enable the security machanisim for nordic nrf52840
i want to use legacy connection with pass key entry feature
can anyone help me how to start ?
i am using ble_hrs_app...
Hello everyone, I have a network that consists of NRF52840 DK and multiple dongles that are pushing the collected data to central, I would like to retrieve data from this...
https://www.nordicsemi.com/-/media/Software-and-other-downloads/Desktop-software/nRF-command-line-tools/sw/Versions-10-x-x/nRF-Command-Line-Tools_10_6_0_OSX.tar
The file...
Hi,
we have developed a device with the nRF52832 that conncects with an Android smartphone. Our connection is secured and encrypted.
However, that doesn't really prevent...
Hi ,Nordic:
I used thingy:91 boards and firmware verison is thingy91_fw_2019-11-29_d3130d77, The board can connect to the nrf cloud, but cannot obtain gps data. We refer...
Hi
I'm reading the documentation and I have some doubts about the nRF9160 board.
So, the board is divided into the micro controller nRF9160 SiP ( https://infocenter.nordicsemi...
Hi Devzone:
I have 1 differential pair and 1 single ended pin I want to read, so I wrote code below into saadc_init function:
In this case AIN4 is the single ended pin...
Hello Support
When calling the function nrf_nvmc_page_erase(0xF7000) (In nrf_nvmc.c) I immediately get a Hardfault error when the code reaches the line where it calls wait_for_flash_ready...
Hi there,
I'm working on nrf52832 and using a PPI channel between a Timer and an SPI to output a voltage, for now, it works fine. But when I try to make it faster, e.g...
