Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
Hello,
We have experienced odd problem, we are not able to scroll up or down SDK documentation at these pages on Android devices. IPHONE browser Safari works ok. Any help...
I am using the S110 softdevice from v8, and building the bootloader from SDKv8, using keil uv5.
The project is dfu_dual_bank_ble_s110_pca10028, loaded from the dfu_dual_bank_ble_s110_pca10028...
Hello, Greetings, in the nRF24L01 datasheet, it's mentioned that the module can work as a multiceiver using the six parallel data pepes,my question is that if it is possible...
on an arduino+redBear Shield 2.1, I read an analog port and write the value to the serial monitor and to my bluetooth connection with
ble_write(analogRead(0));
Serial...
I can't find anything related to this in the docs :(
In the client_handling.c is a function static void on_evt_hvx(ble_evt_t * p_ble_evt, client_t * p_client, uint32_t...
I have been unable to get an ISP130301 module to work with the example dfu s110 bootloader. Dual band, single bank, all of the sdk and SD variants. I've followed the tutorial...
I want to store sensor measurements taken every 2.5ms persistently. Does a write to the internal flash happen faster than this? Can I safely assume that the internal flash...
Could somebody, please tell me what it means? I couldn't find it in the docs.
uint32_t bleDeviceManagerInit()
{
uint32_t errorCode;
dm_init_param_t params;
dm_application_param_t...
Hi, can someone help designing one PCB antenna (1.6mm PCB thickness)?
Also, I intent to do another design using with amplifier and di-pole antenna (also in 1.6mm PCB thickness...
Hi All,
Complete newbie here... Essentially I'd like to modify the nRF51822 smart beacon kit to also advertise it's battery level. From this link it certainly seems possible...
I'm developing an application based on SD130 1.0.0 (latest) and DevKit board with 51422 chip.
The application uses timer for some synchronization purpose. Operation with...
