Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
I'm reading the SDK15.2 documentation coming from SDK 11. I've noticed the nrf_pwr_mgmt module, but I haven't seen it utilized by any of the examples. When should this module...
I implement basic Thermostat Zigbee device on top of FreeRTOS v10.0.0 with nRF Thread and Zigbee SDK in version v3.0.0 When there is no network to connect then after some...
I am working long nrf52840 and trying to implement long range in my project. There were examples in SDK 15.2.0 but i couldn't find any example or post which is related to...
Hey,
I'm using the nRF52840 dongle with SDK15.3. Am trying to make it a central device that is configured as a HID mouse when plugged. So I'm combining both multilink_central...
Hello everyone,
I got an issue with the custom board nRF52832 ( Raytac BLE module ) as I only achieve very short distance between the BLE device and Android app without...
Hi,Master:
When I use the QSPI library to communicate with flash, everything works fine. After a complete read and write, nrfx_qspi_uninit() is called to reduce power consumption...
Hi i am using nrf52832 development board as central which scans for peripheral devices.
how to get peripheral device service UUID(128 bit) completely before connection?...
Hi there,
About radio packet config, would someone please help?
1. Meaning of the LENGTH filed in packet structure. Is it size of payload or of the whole packet? ...
Hello, In a product already in the hands of the users we started getting some issues when connecting to Android Devices
Using the nRF Connect Android Application whenever...
Hi, I have been working with my nrf51 DK for a while now without problems. When I first connected the board to the computer today, the ld5 led was blinking very quickly, and...
hi
i have a question. I'm working on a type of beacon system and need to advertising repeatedly unique beacon in less than 100 ms advertise interval that limited on non...
Good day!
In Light Switch example I made some changes to have GPIOTE events, instead of Simple HAL.
Now, when I try to publish message, debugger shows error in bearer_event_in_correct_irq_priority...
