Hi,
I'm attempting to obtain sensor values for a project to be completed less than a week from now and I have not yet started programming so any help would be greatly appreciated...
Hi
I am using nrf52832,SDK version: SDK : RF5_SDK_17.0.2 .
USE CASE:We have two central and one peripheral.We need to control two central with one peripheral(REMOTE...
Hello,
I am facing an issue with SPI when the SoftDevice S132 is enabled and i cannot figure out what the problem is.
The following test works perfectly when SoftDevice...
Hello!
So I can connect, disconnect and write to my applications characteristics via a PyQt5 GUI I threw together. On the python backend, I use Bleak to
search for devices...
Hi, I am developing using nrf52832 and st7735s.
Successfully displayed the lcd screen using the code in \examples\peripheral\gfx
However, when screen clear, text_8print...
Dear friend I checked the data sheet of 52820 and I didn't see any LPCOMP peripherals. Check the data sheet of 52832, there are LPCOMP peripherals. Comparing COMP and LPCOMP...
Hi,
I have spend some hard time trying to figure how to work with RAM retention. Looks like it is working for me now, but now I retain all available memory. How much energy...
Hi Nordic,
As far as I can see, there is no nrf5340 board support in nRF Desktop application in NCS 1.5.1. May I ask, is there a plan to support it? The nrf desktop gaming...
Hi!,
We are in the process of developing BLE Mesh for Lighting applications. We are currently working with nRF52840 DK. We have successfully tested BLE Mesh models for 1...
Hello
My application is based on the ble_thread_dyn_mtd_coap_cli example which allows to use Thread and Bluetooth in parallel. I would now like to secure the bluetooth connection...
Hello!
I have followed nrf connect sdk tutorial part3 and have walked through for bme280. But now I want to connect two or more bme280 sensors to my dk. How should I modify...
Hello,
I have an application where a BLE central connects to a BLE peripheral. Then the devices do the bonding procedure. After the devices are bonded the peripheral should...
I am testing the nRF9160 DK (PCA10090 with PIN) on the Bell Canada LTE-M, run into some problem and will appreciate some help.
At the beginning, the newest demo asset tracking...
Hi,
For Direct Test Mode on nRF Connect for Desktop, I have confirmed that Constant carrier can be selected.
The log was obtained at the time of the following settings...
NCS Release v1.5.1 now supports PA LNA, couldn't see any BLE examples on how to configure and use PA/LNA. could you provide any instruction/guidelines on how to enable/use...
Hello.
I'm using the NRF52832 with I2S module connected to TLV320DAC from TI. I've configured the DAC and I2S module successfully. I'm getting audio output (simple sine...
Hello,
I hope you are well.
I am currently working on interfacing an INTAN RHD2164 chip with the NRF52840. This chip is connected in SPI with the NRF52840. The only problem...
I tested NB-IoT and MQTT in NRF9160, and the device could normally search for NB signals and connect to our background through MQTT protocol. After the device uploaded data...
NRF52840, S140, SDK 14.2
I am trying to write to an SD Card. But whenever I insert the card, I get a failure on ASSERT. I believe this is because I am using P0.0 as the...
