Hello,
I have tried twice to request for SUPL license for getting A-GPS working but it has been denied both of the times. I think first time it got denied due to mismatch...
Hi Nordic Team,
The atomic fifo implementation is based on armv7-M, right now I want to port it into cortex-A processor, I made some changes to get it compiled without...
Hi,
Kit:nrf5340
Can you please tell me if there is any example in nrf connect SDK v1.5.0 related to data transfer concepts.
Is ble controller will be enabled during...
I'm was testing the gsp sample in samples/nrf9160/gps. It runs fine on my nRF9160DK and reports NMEA messages. However, when i ran it on my custom board, it failed in setup_modem...
Hi,
I'm attempting to obtain sensor values for a project to be completed less than a week from now and I have not yet started programming so any help would be greatly appreciated...
I am working in sdk14.1 nrf52832 ble_app_hids_keyboard_pca10040_s132.
I have successfully implemented a keyboard + Consumer control command in the HID service.
It works...
When I only used XXLARGE block, I got bellow error:
..\..\..\..\..\..\components\libraries\mem_manager\mem_manager.c(484): error: #94-D: the size of an array must be greater...
Hello,
I'd like to keep an epoch time on the nRF52 by incrementing a 64-bit second counter in RAM by using app_timer once per minute (happy with this granularity). Between...
Hello everyone,
I know this issue is quite recurrent but I've gone crazy reading so many different issues with android version, Connection intervals, etc. Would like to...
Hi all,
I'm working on a implementation of the nfc url to my custom nrf52832 product.
I would like to run the record_url example on my custom application. I made a library...
There is the board mark on the chip like n51822CEAAD01350A0, where DO is Build code, 1350 is tracking code(YYMM), A0 is lot code.
Taking below package marking for reference...
Hello,
I am currently experimenting with some throughput tests on nRF52832/nRF52840 DKs. Some time ago I worked with some BLE UART examples from SDK 13.0 with the help...
Hi,
I want to sample lpcomp result at 50us, I'm doing so by using the following statements and set/clear a gpio based on the lpcomp result:
nrf_lpcomp_task_trigger(NRF_LPCOMP_TASK_SAMPLE...
i use BLE uart project SDK 11 NRF 51822 with 2 value min max conn interval default is 20 and 75 ms.
i use android App was built by my team, and it' hard connect to NRF...
I am looking for a best solution to this scenario as in title:
I read in some posts (eg. this post ) that can use multiple ble service instances
also in...
I have followed the well written blog post on how to create custom service on this site. I downloaded the sdk 13 code for the same and i can send and receive values on the...
System:
-nRF51822, SDK11, Eclipse with GCC
-Project based on dfu_dualbank_s132
Intention:
Flash the combined SoftDevice, Bootloader and Application, where the...
When I call nrf_gzll_enable(), then nrf_gzll_disable(), and go to sleep with __WFE(), there is about extra 6uA draw due to this enable/disable action. It seems the nrf_gzll_disable...
