I'm having some trouble successfully entering ON,IDLE mode. I have pared-down my application to do the following:
Initializes the app_timer using the scheduler:
...
I want to control GPIO toggle by PPI. Timer1 is in timer mode. CC[0] is 1000, and CC[1] is 8000.
I use compare[0] to toggle gpio18 by PPI. I also want to use compare[1] to...
Hi,
I use two evk board to connected and test the uart serialization sample(ble_s110_serialization), one is ble_app_hrs and one is ble_app_connectivity. But I have one...
I am getting get BLE_EVT_USER_MEM_REQUEST and BLE_GAP_EVT_CONN_PARAM_UPDATE event, when writing to ble device, sample code did not handle these event, and seems no document...
Hello:
Why do I erase SDK5.2 version of flash and read not, in SDK4.2 can. I tested nrf51_sdk_v5_2_0_39364\nrf51822\Board\nrf6310\flashwrite_example is a good example.However...
before i write the flash, it has been erased.so ,its value is all 0xff.
when i write 0x00 to flash address 0x0001,the value read out is not 0x00 but 0x01,and the value in...
I am trying to implemented a mechanism for authenticated debug on NRF52840 on NCS 2.5.
My understanding from the product specification is that DAP protection is enabled...
HI，
The current SDK version I'm using is 3.0.0 for nrf54L15. I want to control the SPIM30 using DPPI, so I'm using the nrfx library to operate the SPIM30. The specific code...
Hi,
We are experiencing a weird issue on our custom boards which have a nrf9151 chip
We are using emnify sims and have experienced the following:
On some boards, when...
Currently designing around the nrf54h20 and wondering if Nordic has any recommendations for properly routing the USB D+ and D- traces.
D+ and D- are supposed to be routed...
First of all I am very new to all of this and have been reading up a lot on the topic.
I am trying to create a walkie-talkie like setup where 2 development kits will communicate...
Hi, I am working on a graduate project about BLE mesh networks. I'm using nRF52840 CKAA 94 pin BGA package MCUs. For this project I need to compare several boards and each...
Dear nRF experts.
We are a module manufacturer. We discovered some issues during power consumption testing. We are currently using the nRF54L15 Dk board and PPK. We are...
Dear Staff,
I have a nrf52833dk application code which I have to "port" on the nrf5340dk. The code implements the following requirements:
Direction finding transmitter...
If an nRF52832 device and a smartphone are paired and only one of the peers deletes the pairing (bonding) information, an error may occur when reconnecting due to a mismatch...
Hi everybody. Can I ask for the details of this PCA64110 flex NFC antenna:
Q) Is this flex antenna using "Gold Fingers"? If so, what is the Gold Fingers Thickness?
Q...
I want to develop a mouse using nrf54l15 now, but I am confused by the macro definitions for Bluetooth. I can only understand the macro definitions for Index, which represents...
Our setup:
Board: nRF5340 DK
SDK: NCS v2.6.2
Microphone: MMICT5837-00-012
Interface: PDM
During mono audio capture over PDM, we observed a current draw of about...
Hello,
we are testing the NRF54L15 for a project that requires BLE 1M and PHY coded simultaneous scanning.
From my understanding, the BLE scanning feature of NRF54L15...
