Using S120 V 8.0.0.3 alpha, processing a BLE_GATTC_EVT_READ_RSP,
received 0x16 bytes of data but there is more to read. Next call to
sd_ble_gattc_read using the same connection...
Hello：
Why Bluetooth Go to system-off mode, sd_power_ramon_set can not be stored. In D: \ RAM save nrf51_sdk_v5_2_0_39364 \ nrf51822 \ Board \ nrf6310 \ s110 \ ble_app_rscs...
Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
Hi there
In the service UUID 0x2A00 I am currently trying to set a device name >31bytes with sd_ble_gap_device_name_set(). I am using the Softdevice S132 V6.1.0.
According...
Hi,
Multi peripheral was introduced as experimental in SDK 14 two years ago and it is still experimental in SDK 16
Our customers highly ask for multiple phone connection...
Source: nRF6939-CD-NVS-5.4-livecd.zip Resource download path failure: www.nordicsemi.com/.../Download-infotabs Please provide me with a valid resource download path
Hi,
Recently, I am trying to make a nRF52810 project to run the sample code based on nRF52832.
The application code size is used in nRF52832, Code=56840 RO-data=9600 RW...
I am trying to use SPI master + UART concurrently on the nRF52840 dongle. I am aware that the GPIO pins on the dongle can be used for SPI or UART. However, when trying to...
My nrf9160 which has the v1.0.0 modem and using v1.0.0 sdk has suddenly started continuouly resetting when i try to run asset tracker application. I have tried at-command...
Hello,
I am trying to build the lte_ble_gateway sample. I keep getting a JavaScript Alert TEST_RANDOM_GENERATOR.
I got something simalure with the bluetooth hci uart...
nRF52811 has only one receiver. Most accurate direction finding can be made based on estimation of phase difference between two signals received in two spaced antennas. Such...
Hello – My project needs to report its indoor position to the cloud (no GPS). I intend on using known positions of iBeacons SSID/RSSI coupled with trilateration math – fully...
Hi team, I developed own project based on /examples/dfu/secure_bootloader/pca10056e_ble/ses/. In the original project there was only Release config (no Debug). I modified...
I am trying to figure out how to configure my peripheral such that when a central client tires to enable the service changed characteristic that it succeeds. I am desperately...
I'm working on an application where I will need to initialize the modem, send/receive messages and then turn it down to low power until the next checkin. I did a real simple...
I have read that at each connection event master will send the first packet (empty payload).
In a case where slave latency > 1, the slave will not be listening to master...
