Hi ,
I would like to know if a matching network is needed if I am only using a single external flex antenna for both LTE and GPS using a RF switch between them and a uFL...
I am a student interested in Nordic.
My coding skills are very poor.
So I want to get help.
I want to use the vl53l1x sensor in nrf52. (My ultimate goal is to measure...
I have a working project where pin 16 is configured as a low-level interrupt source.
it is working well with SDK 15.3
after porting to SDK 17.0.2, it is not triggering...
Hello Nordic Support Engineers and fellow developers ...
Just a note to thank everyone for help via this forum. I started very inexperienced with Nordic SDK a year ago and...
Hi,
I recently purchased a thingy91 for a project. I'm trying to follow instructions from a Nordic youtube video ( https://www.youtube.com/watch?reload=9&v=xQ7hDzRULJQ ...
I have a nRF5340PDK, Now I want to know the lowest power consumption of this chip in different condition, such as adv, connect, sleep. But I am not sure how to config the...
Hello,
I'm a beginner in IOT and Nordic products.
I followed the steps given in the tutorials given by the Nordic developer zone and made the SDK act as central/peripheral...
Hi,
In my application I need radio notification only during connection. When connection is dropped the peripheral goes to advertising mode and here i disable the radio...
Hi all again guys! I am experiencing a problem with my application: i have a beacon that is sending ADC converted values to a nrf51 DK (via notification), which is connected...
Hello,
I want to use SPI between one nRF51-DK (using SD130 v 2 and SDK11) and another board. I am supplying the nRF with 2.3 V and initializing the BLE and the SPI. I can...
I have a BLE application in mind in which it would be useful for the BLE server to obtain the battery level of the BLE client (in this case, a phone, laptop, or tablet). I...
Hi,
Is Nordic looking to support mbed OS on the nrf51/nrf52 series chips?
Currently it looks like the best supported platform is the mbed Classic SDK, but it looks like...
Hi,
I am trying to make a program for the NRF51 development kit on mbed. I have been able to take ADC samples at 1000Hz which is what I want, but I can't seem to print...
In SDK 11 description od DTM "vendor specific" settings, there is a lot of inconsistency in parameters names/numbers - could anyone help me understand this part?
As for...
Hi,
Everyone,
I have firmware working with our custom pcbs.
It works fine with new 3.3v battery.
But somehow it does not advertise anything with used battery having...
I have a digital microphone chip, it has the CLK, DATA, LR_SEL three pins, now I will pick up the three pin nrf5283 three pin is as follows: CLK connectionI2S_CONFIG_SCK_PIN...
I guess we need some help with definitions. Basically, we'd like to read data from an I2C line. Should be as simple as "set to input" and "read the pin". However...
In...
Using nRF5 SDK v11.0.0, I am working on bringing up new hardware based on the nRF52. I started with code that works on the PCA10040 development board in which we connected...
