Hi,
I have a SPI slave device which outputs 8-bit registers that I have to assemble. For example, I receive two 8-bit registers, a high and a low register, which I have...
I have a PCA10059 dongle. I have inadvertently configured pin P0.25 as the sleep debug pin and I use active state 0 as I am using off board LEDs with reverse logic. This means...
If you're working on a product that requires you to show and translate GATT Attribute (Service, Characteristic and/or Descriptor) UUIDs to Strings to the user, it's likely...
Hello,
We have been trying the sendNotification call and after getting a success log we are not able to send a second notification. I'll copy the snippet of code that we...
I have a firmware developed on the nrf52840 development board. When porting it to nrf9160, a lot of errors were reported. How can I use the LOG output function on nrf9160...
Hi I would like to ask you for advice on how to solve my problem with Ble and the timer I am trying to add a timer to examples\ble_peripheral\ble_app_uart the timer works...
Hello,
I want to add the Thingy 91 to the nRF Connect Cloud. The SIM was activated correctly. I've inserted the SIM card and know I'm waiting for the LEDs to blink yellow...
Hi, I am using the UART over BLE example + a timer interrupt + a pwm signal. And I am facing the following problem (error launched by my phone app: ) This happens sometimes...
Hi ,
In order to capture and get the data from the external BLE beacons,
I am trying to simulate this using nrf connect Advertiser option instead of using Beacons...
Hello, i have been unable to read data from my sensor.
uint8_t SPI_ReadByte(uint8_t RegAddress) { ret_code_t retCode = NRF_SUCCESS; //start reading sequence m_tx_buf[0...
The modem reports that it supports states 0, 1, 4, 20, 21, 30, 31, 44 when I give the "AT+CFUN=?" command.
Using the at_client sample, or other software like asset_tracker...
Hi, I am using nRF52 DK with s112 and SDK V15.2.0. I have written an application based off of the uart example, and expanded it rather substantially to use the SAADC and read...
Hi,
I'm trying to create my switch_event by using Event Manager.
And I got this issue: "undefined reference to `__event_type_switch_event' " when submitting my event:...
Windows 10, Segger V4.52c, S132, SDK 15.2.0, nRF52832
I've been through a few posts talking about needing more RAM allocated to the SoftDevice when other services are added...
Is it possible to generate a DFU package for both bootloader-only and fully-programmed (bootloader, softdevice, and app) chips? I'm unable to do so for an nrf52833 using nrfutil...
Converting old code for a nRF51822 to the new SDK(15.3.0) for an nRF52832, this error happens:
#error "Compiler generates FPU instructions for a device without an FPU (check...
Hi all,
After wasting so much time trying to set up simple peripheral device whitelisting single central device, I realised that API has been updated and those old examples...
Hi all,
Can I read the chip ID of NRF24LE1 in code? how can I get the ID?
Or is there any readable identifier that make each chip "unique" from each other? Because the...
