Hi Nordic Team,
The atomic fifo implementation is based on armv7-M, right now I want to port it into cortex-A processor, I made some changes to get it compiled without...
Hi,
Kit:nrf5340
Can you please tell me if there is any example in nrf connect SDK v1.5.0 related to data transfer concepts.
Is ble controller will be enabled during...
I'm was testing the gsp sample in samples/nrf9160/gps. It runs fine on my nRF9160DK and reports NMEA messages. However, when i ran it on my custom board, it failed in setup_modem...
Hi,
I'm attempting to obtain sensor values for a project to be completed less than a week from now and I have not yet started programming so any help would be greatly appreciated...
Hi
I am using nrf52832,SDK version: SDK : RF5_SDK_17.0.2 .
USE CASE:We have two central and one peripheral.We need to control two central with one peripheral(REMOTE...
Hello,
I am facing an issue with SPI when the SoftDevice S132 is enabled and i cannot figure out what the problem is.
The following test works perfectly when SoftDevice...
we are working on a project which required to use usb cdc acm. compare with normal serial, the usb cdc acm always lost some packages when chip start and reboot. do anyone...
Hello,
I'm experimenting with nRF52840 Dongle and successfully flashed ble_zigbee_dynamic_color_light_bulb_thingy . I also connected it to my Samsung Smarthings hub (Zigbee...
Hello,
I am running application with softdevice s130 and nRF51_SDK v 12.2.0 on a custom board. The interrupts that are used by the SD are not used anywhere by the application...
platform:52840
Protocol stack:s14
IDE:keil v5.26
Hi,Master:
I want to simulate in a long time,I turned off the watchdog and also turned off the Bluetooth broadcast...
I want to use 52832 to measure the frequency offset and Modulation Characteristics in the advertising packet sent by Bluetooth slave.How can I do it? I think this information...
Hi All,
I am working on FOTA feature for Thingy91. My country is Vietnam and I only can use NB IoT to connect to cloud service.
I tested project FOTA example. My device...
The nRF52840 has a longer rx characteristic reception time than the nRF51822.
--> android terminal log
first and second line nRF52840 , It takes almost 1.2 seconds...
Dear All,
I need to know if there is anyway that I can update the data of the advertisement package of an iBeacon on the fly, while using Zephyr OS.
What I effectively...
Hello,
I've written a shell cmd on the 9160DK to send an sms. it handles getting the data in the correct has the following format,
sms <len> <pdu data>
I've used the...
hello,
I am trying to integrating ble_nus_init( ), inside ble_beacon_app, receiving through NUS_service and transmitting through beacon,
but program is stuck inside ble_advertising...
Is it possible to assign connection handles non-sequentially, for example based on the device's Bluetooth name? For the solution I'm developing I'd like for a given sensor...
Hi,
I am getting lots of transmission errors using the Serial library. I changed the Serial_Uartes example by removing the serial1 interface and creating a simple loopback...
Hi all,
I am using nRF52832 DK to do some tests about power consumption. And I am facing a problem that every time I pressed the button and kept it down, the current would...
Checked out v1.0.0
This error seems to be unavoidable to me. I have deleted the git cache and even tried the --no-cache-dir option to pip3, but nothing seems to work.
...
