Hello,
I have tried twice to request for SUPL license for getting A-GPS working but it has been denied both of the times. I think first time it got denied due to mismatch...
Hi Nordic Team,
The atomic fifo implementation is based on armv7-M, right now I want to port it into cortex-A processor, I made some changes to get it compiled without...
Hi,
Kit:nrf5340
Can you please tell me if there is any example in nrf connect SDK v1.5.0 related to data transfer concepts.
Is ble controller will be enabled during...
I'm was testing the gsp sample in samples/nrf9160/gps. It runs fine on my nRF9160DK and reports NMEA messages. However, when i ran it on my custom board, it failed in setup_modem...
Hi,
I'm attempting to obtain sensor values for a project to be completed less than a week from now and I have not yet started programming so any help would be greatly appreciated...
Hi
I am using nrf52832,SDK version: SDK : RF5_SDK_17.0.2 .
USE CASE:We have two central and one peripheral.We need to control two central with one peripheral(REMOTE...
Hi there
In the service UUID 0x2A00 I am currently trying to set a device name >31bytes with sd_ble_gap_device_name_set(). I am using the Softdevice S132 V6.1.0.
According...
Hi,
Multi peripheral was introduced as experimental in SDK 14 two years ago and it is still experimental in SDK 16
Our customers highly ask for multiple phone connection...
Source: nRF6939-CD-NVS-5.4-livecd.zip Resource download path failure: www.nordicsemi.com/.../Download-infotabs Please provide me with a valid resource download path
Hi,
Recently, I am trying to make a nRF52810 project to run the sample code based on nRF52832.
The application code size is used in nRF52832, Code=56840 RO-data=9600 RW...
I am trying to use SPI master + UART concurrently on the nRF52840 dongle. I am aware that the GPIO pins on the dongle can be used for SPI or UART. However, when trying to...
My nrf9160 which has the v1.0.0 modem and using v1.0.0 sdk has suddenly started continuouly resetting when i try to run asset tracker application. I have tried at-command...
Hello,
I am trying to build the lte_ble_gateway sample. I keep getting a JavaScript Alert TEST_RANDOM_GENERATOR.
I got something simalure with the bluetooth hci uart...
nRF52811 has only one receiver. Most accurate direction finding can be made based on estimation of phase difference between two signals received in two spaced antennas. Such...
Hello – My project needs to report its indoor position to the cloud (no GPS). I intend on using known positions of iBeacons SSID/RSSI coupled with trilateration math – fully...
Hi team, I developed own project based on /examples/dfu/secure_bootloader/pca10056e_ble/ses/. In the original project there was only Release config (no Debug). I modified...
I am trying to figure out how to configure my peripheral such that when a central client tires to enable the service changed characteristic that it succeeds. I am desperately...
I'm working on an application where I will need to initialize the modem, send/receive messages and then turn it down to low power until the next checkin. I did a real simple...
I have read that at each connection event master will send the first packet (empty payload).
In a case where slave latency > 1, the slave will not be listening to master...
