Hello,
I'm new to the Nordic SDK and I would like to ask you for help with implementation of PORT events for revision < 3 in "low power" mode instead of "high power" mode...
Hi Nordic,
I've built a ble app with a custom protocol, but am struggling with storing bonds, when running under freeRtos.
What I see:
central app crashes (hardfault...
Hello All,
I am new to this forum, I have been using nRF51822 for a while, and its a great little BLE chip. I am usinga BLE keyboard to send a key to iphone and I captured...
I WANT COMMUNICATION BETWEEN A NRF51422 AND NRF528321 BOARDS, IN WHICH IN NRF51422 BOARD I WILL MEASURE PWM COUNT(IT IS PHERIPHERAL) AND SEND IT TO NRF528321 BOARD WHICH IS...
Hi,
I've been working on a way to detect and prevent replay attacks when beacons are used for sensor data. This is mostly used for home automation sensors, where I have BLE...
Hi,
For our current application we have migrated from SDK 13 to SDK 14. We are using RTOS to handle the functionalities of our application. We replaced our own task for handling...
hello,
I use nrf51822 + S130 + SDK12.2 in my product, nrf51822 work at central + peripheral mode，and i use nrf_duf_flash module for my dfu funtion.
The problem is, i...
Hi all , when I combine light switch server and remote server in 1 Node and use Provisioner Node for provisioning and config for it . I have error
Log in provisioner : ...
Hi,
I have to transfer messages every 100ms and to receive confirmation about successfull reception.
Message is sent from the phone and should make two hoos and return...
Hello,
I'm using the PWM peripheral to generate a waveform. The waveform is loaded into RAM and then I use the SEQ[n].PTR and SEQ[n].CNT registers to set up the DMA. The...
Hi to all,
i am working on a project based on nrf51822 soc, i want measure level of battery with nrf51822 ADC channel.
i have an example code that measure the level of...
Hi all,
I can't get the Blinky example working on my PCA10040 kit. After flashing, LED1 stays on and there is some activity on LD5 but the kit is not detected on all my...
Hello,
I'm currently developing an application using an NRF52832 and SDK15 (SD 6.0.0). I have an issue that causes an UART overrun during some flash operations and it somehow...
I was wondering if it was any use to make use of gains 2 and 4, and noticed the errors for those gains are missing in the PS.
So do gains 2 and 4 actually increase the resolution...
i want to sinchronyze diferent peripheral and 1 central thank's to the gpiote's state.
but i have a error 8 invalid state whereas i had initialize
help me please !!! ...
I am using nordic nrf52840 sdk kit as a peripheral and mi 5A mobile as a central .The problem is continuously disconnecting with following reason
Reason: Remote User Terminated...
I am trying to read values from an analog peripheral device. To perform an analog read, I am using this example from the NordicSnippets simple examples:
https://github.com...
Hi, I have been trying this for 3 days.
I was using DBGX_EVTX in SR3v1.1 to check the log, it works fine and never goes wrong.
But in v1.2, is using another function instead...
Hello everybody,
I am using central device with SDK14.2 and S132.
In a central application, the operation sequence is as follows: * Buttons pressed and scan started *...
