Hi, is there an available developer in my tri-state area of Minnesota, N. Dakota, or S. Dakota? Please call me if you are available for a project for hire. The developer should...
I'm trying to design a very low power sensor that takes readings using ADC and SPI 200 times a second. I'm a bit worried by the current EasyDMA uses (1.1mA). As far as I can...
Hi, I am working on a project where I want to make one nrf51288 chip as central hub and connect that to a android phone and other salve nrf51288 .
idea similar to this: ...
Hi,
I have a code programming the nRF51422 development board to write to a Sharp Memory 96x96 pixel LCD screen using SPI.
Currently the code writes two numbers and a...
I've modified the ble_app_uart example by adding GPIOTE so that the transmitter sends a character to the receiver when a GPIO pin is toggled. This part is working well.
...
Hi,
I am working on my hardware product having nRF-51422 chipset. I just came to know from forum post that
nRF-52 chips will get arduino IDE support as standalone. I want...
Hi there, I'm using nrfutil ( nrfutil version 6.0.1 ) to dfu via ble (dongle),
Mac (10.15.2), windows (10), linux (raspbian) have been tried out to update the firmware none...
I am using the '840 to construct a small network using the ESB stack. In this design, a master (dongle) transmits to each slave and receives an ACK w/payload response. The...
I changed the way to get the upgrade program in the bootloader program and wrote a function to write the accepted bin file to the bank0 area. However, I found that it took...
Hi,
I am using BMD300 rigado board having nrf52. In my application i am tracking the ADXL362 accelerometer's motion.For this, I am combining SPI, UART(for displaying data...
Good evening,
after a very long research I couldn't find any answer.
Is (and if, how) it possible to connect an Arduino (or ESP32) via SPI, I2C etc. with the nrf52840...
Hi,Nordic Team
I tried to set 0,1,2 modes respectively in GNSS option, and the test current is as the attachment .
0 1 2
/**@defgroup nrf_gnss_psm_modes Values indicating...
Hi,
I am using nRF52832 with s112 BLE stack and SDK v16.0. I am wondering what is the most proper way for the "idle_state_handle()" method in the main loop.
Currently...
Hello,
I need to have connection status at the application level (IOS).
I'm working with the example "light switch server proxy" where the heartbeat profile is working...
Hello, I modified the instance in usbd_hid_generic to simulate it as keyboard. I checked the code of NRF52840 on github about the keyboard. It USES the function app_usbd_hid_generic_in_report_set...
Hello,
I really like your products since nRF51 but I noticed the same experience issues every time.
I tried your nRF9160 DK with the new SDK and I’m very disappointed...
Hello,
I am using NFC example "NFC BLE pairing reference", I could not paired with mobile phone through NFC. My android phone has version 10. The first time it paired successfully...
In my BLE project at the scanning side I see that application gets held if I remove filters from scan_init API and calls nrf_ble_scan_connect_with_target. I am refering to...
Hello
I'm working on my ble central that is based on nRF52832 and it's connecting to nRF52832 peripheral setup with Enviromental sensing service[ 0x181A]
This is log from...
