Dear Developer Zone,
I am new to ANT and am looking for someone to help me to setup an example 15 channel (14 devices) ANT network using the S332 soft-device to test communication...
Hello,
i am working with the Enhanced ShockBurst proprietary protocol and i am wondering where I can find the sources of this protocol, so that I can do some changes. ...
[uart - Copy.rar](/a master _error.png ttachment/3cc01f5e2484d2b0f33e62befd3e6a62)
hello there
I am interfacing master nrf51 dk with nxp's slave lpc11u24
(1) my main...
It is good practice to prefix the includes from one's C libraries with a directory so that they are all part of the same 'include namespace'. Unfortunately the Nordic SDK...
Hi, is there an available developer in my tri-state area of Minnesota, N. Dakota, or S. Dakota? Please call me if you are available for a project for hire. The developer should...
I'm trying to design a very low power sensor that takes readings using ADC and SPI 200 times a second. I'm a bit worried by the current EasyDMA uses (1.1mA). As far as I can...
Hello,
We use NRF52 and the SPI protocol to read the ADS7866. But we are facing a problem when reading at high speed, we want to make one read transaction of 2 Bytes every...
Hi everyone,
in our project we transmit from an android app to Nordic BLE big amount of data (up to 180.000 bytes). I do it by using hvx notifications (MTU 247) and each...
I am trying to get nRF52832 working with Segger Embedded Studio. All the examples happily compile and load and run on the board.
But, I want to write my own basic hello...
Hello, I'm using SDK 15.3.0 throughput test and I want to change TX power to +8dBm. In documents it says change the power from sd_ble_gap_tx_power_set but I couldn't find...
Hi everyone,
I'm using the nrf52832 Dev Kit PCA10040
SDK version: 15.3.0
OS: Fedora
I try to use DFU following this tutorial but I can't see my application on...
Using SDK v11.0 and SD v2.0.0 on nRF52832 with ARM GCC.
I want to copy page(s) content to another page(s), I tried the following but couldn't succeed.
When I used the...
Hi,
I am using nRF9160 DK with Zephyr RTOS and able to successfully build asset_tracker in SES with the help of getting started tutorial. But I have getting problem to send...
Hello there,
I have used the nRF52840 DK to find the rssi values of all peripheral devices using the interactive example. I would like to create a command to find the rssi...
Hi,
I am developing sensor products with zigbee (nrf52840).
I have successfully test that sensor data is received by coordinator.
Network is as follows.
ZC(1)...
Hi,
I have a project where my nrf9160 is able to enable and get a fix with GPS and turn in on and off. I am trying to enable LTE when the GPS is off. Here is my procedure...
Hello Nordic,
We have constant success with provisioning servers into the mesh and communicating to smart devices via proxy node. However we do all provisioning with the...
