Hi, is there an available developer in my tri-state area of Minnesota, N. Dakota, or S. Dakota? Please call me if you are available for a project for hire. The developer should...
I'm trying to design a very low power sensor that takes readings using ADC and SPI 200 times a second. I'm a bit worried by the current EasyDMA uses (1.1mA). As far as I can...
Hi, I am working on a project where I want to make one nrf51288 chip as central hub and connect that to a android phone and other salve nrf51288 .
idea similar to this: ...
Hi,
I have a code programming the nRF51422 development board to write to a Sharp Memory 96x96 pixel LCD screen using SPI.
Currently the code writes two numbers and a...
I've modified the ble_app_uart example by adding GPIOTE so that the transmitter sends a character to the receiver when a GPIO pin is toggled. This part is working well.
...
Hi,
I am working on my hardware product having nRF-51422 chipset. I just came to know from forum post that
nRF-52 chips will get arduino IDE support as standalone. I want...
Hi!
I've been using PCA10028 for a long time and I had some bricking issues but I've managed to un-brick it with "nrfjprog --recover" and everything would work again. ...
Hi,
I would like to test the ZigBee throughput like the examples ("ATT_MTU Throughput Example" for BLE and "Thread Throughput Measurement Application").
I'm not familiar...
Dear Support,
I am working with the new SDK 15, and got some question about using whitelist without device manager, and without pairing or bonding. As stated here: https...
I'm using v14 of the SDK and I cannot for the life of me get either the external 32MHz or 32.768kHz clocks working.
How is this possible using the SDK?
Our company is manufacturing security and telecom products. In our security product range, we are adding blue tooth based product which is under development. For this product...
I'm trying to add buttonless dfu to my app using the example from SDK14.1. It seems no matter how I adjust the memory I'm getting a NRF_ERROR_NO_MEM from ble_dfu_buttonless_async_svci_init...
Hi,
I have couple of questions about provisionning/configuration process:
1- I'm scanning with my phone and many ble devices show up (my devices and neighbor devices for...
Hi,
For my project I'd like to be able to remove GATT services/charactertistics. Is this possible? I can understand not being able to remove single services, but is it...
Hi
The application I'm currently working on has three debug settings:
DEBUG preprocessor symbol
Optimization level 0
NRF_LOG at debug level (using RTT)
...and...
On my custom board I have a button BUTTON_1 in between supply voltage (Vbatt = 3V) and input on nRF52832 - therefore input will receive 3 Volts directly.
I have configured...
Hi,
I am developing a code in which, among other things, when a button is pressed, a led turns on. In the same button handler, a timer is started to turn the led off a bit...
I'm trying to evaluate throughput performance of our BLE application which operates in conjunction with the Apple platform. I would like to know if there is a way that I can...
I created a system some years ago that worked the way as the title suggests using classic bluetooth, and a cheap chinese module (HC-05) with custom firmware. Now I want to...
Hello!
I'm having some problems with Keil. It does not seem to have the board (52DK / nRF52832) installed. I've installed Keil 5.25, and in the pack installer I've added...
Hi to all,
i am developing a device with nrf51822 soc, i want to read some data from flash storage of nrf51822 then forward it on ble, i implemented a code for this job...
