Hi, is there an available developer in my tri-state area of Minnesota, N. Dakota, or S. Dakota? Please call me if you are available for a project for hire. The developer should...
I'm trying to design a very low power sensor that takes readings using ADC and SPI 200 times a second. I'm a bit worried by the current EasyDMA uses (1.1mA). As far as I can...
Hi, I am working on a project where I want to make one nrf51288 chip as central hub and connect that to a android phone and other salve nrf51288 .
idea similar to this: ...
Hi,
I have a code programming the nRF51422 development board to write to a Sharp Memory 96x96 pixel LCD screen using SPI.
Currently the code writes two numbers and a...
I've modified the ble_app_uart example by adding GPIOTE so that the transmitter sends a character to the receiver when a GPIO pin is toggled. This part is working well.
...
Hi,
I am working on my hardware product having nRF-51422 chipset. I just came to know from forum post that
nRF-52 chips will get arduino IDE support as standalone. I want...
Hi!
I've been using PCA10028 for a long time and I had some bricking issues but I've managed to un-brick it with "nrfjprog --recover" and everything would work again. ...
Hello,
We are considering using the Thread protocol for in an application where we have one or more central devices distributing data to several peripheral devices. However...
I'm working on TWI with nrf52832 dev board, using examples from SDK 16. Here's the code:
I see no activity on the logic analyser and the application gets stuck in the...
Hello, Im working on project that communicate with gps/gprs and it works with the example/peripheral/libuarte. but when I want to integrat it (add) it to central peripheral...
Hello Support
I have an error when I try to add a custom CLI command with the API "otCliSetUserCommands()" . I added two commands for my example. The commands work fine...
Using the following:
Rigado BMD-360 nRF52811 development board.
Softdevice S140 7.0.1
SDK 16.0
Using two development boards inches apart, one development board sends...
I flashed two nrf52832 with a black magic probe. Unfortunately after reconnecting the USB, I wasn't able to flash them anymore. So, I tried the nrfjprog command line program...
Hello,
Our application is currently based on the Nordic SDK services such as app_scheduler and app_timer. It is not possible to change this to use an RTOS do to regulatory...
Hi Devzone:
I am trying to gauge the power consumption after nrf_power_system_off() is called.
So is there a list of the hardwares that "nrf_power_system_off()" shuts...
I am using nrf52832 radios to communicate using ESB without DPL. I have selective_auto_ack=true and I set the payload.noack=true. But each time I transmit and there is not...
I am trying to create a description of my peripherals in the device tree. For example, I want to describe the pins that will control the input type for the ADC. Current input...
Open LTE Link Monitor OK, but point connections appear with the following blank interface
Here's the LTE Link Monitor that shows the blank
LTE Link Monitor is...
Hello,
I am using NRF52840 with SDK 16.0.0 and Mesh SDK 4.1.0
.I am trying to use SAADC with BLE Mesh(SDK 4.1.0). I used default example of SAADC with multiple channel...
I am new to nRF9160 development board. I have just opened the board and tried to connect following the startup instructions. I was able to see LED 3 and LED 4 blink the first...
Hi all,
I am trying to get a hang of SES platform(Using the nRF52840 Preview DK, SDK 15.3) and it's my first few trails with it. I am trying something very basic now to...
