Hi.
I am using the NRF52 Development board, on Keil uVision, to implement a C program that uses Dynamic Structs. The Structs re-size themselves ( by increasing their capacity...
Hello,
I have an NRF51822 (redbealab ble nano) that I would like to use to count pulses in very low power mode.
Pulses are asynchronous
The rate of pulses can...
Hi
I'm attempting to read a PT-100 sensor value that is part of a voltage divider using a nRF52.
Both the reference resistor and the PT-100 is sampled while the voltage...
Hi
I have been searching the forums, but were not able to find an answer to my question.
I'm trying to sample 4 analog inputs on the nRF51-DK using the ADC hal. (SDK10...
Hi
I have been trying to get two NRF24L01 chips communicate with each other since a week now, without much success. All what I can find on the net is Arduino examples using...
Hi
I have done several projects with the nRF905. I know the device quite well. Normally I use the CD, AM and DR interrupt pins to determine the status of the device, my current...
i made this project to try to create RSC service on arduino
developer.bluetooth.org/.../runningspeedandcadence.zip
unfortunately the server starts but i'm not able to...
Hi. I have a problem, after upgrading the plugin nRF Connect for VS Code to a version higher than (2021.10.103) do not load modules of this plugin (photo attached). If I install...
Hello,
We are trying to setup the building environment for a nrf9160 device. We use the nrf Connect Desktop Toolchain for installing the environment and then we download...
Hi,
I want to connect to Google Cloud IoT with a modified asset_tracker and want the TLS done by the modem like in asset_tracker.
Google has a primary and a backup root...
Hi there!
After having worked with the nRF5 SDK and nRF SDK for Mesh, I'm off to a start for a project with LTE; CoAP to be precise. I'm using the nRF Connect SDK with Visual...
Hi,
I am working on a 2-wire uart to save GPIO and try to get as low current consumption as I can get.
Here is how I want it to be:
My custom 52840 board have 2-wire...
Hi,
I have created a custom board with a nrf52840 on it. I am working with Embedded Studio v5.64 and the Nordic SDK v. 17.1.0. When I use the preprocessor definition BOARD_PCA10056...
Hello Nordic experts,
Recently, I would like to implement high throughput with multi links. to optimize the system, I have the following doubts:
First of all, let...
I've recently put nRF Connect on my new machine, v1.7.0. I wanted to test the peripheral_uart sample application. However when I go to compile the peripheral_uart example...
Is it possible flash a nRF52833 over Bluetooth using the nRF52840 (PCA10059)? Or initiate DFU mode over Bluetooth using the dongle or a PC?
How could this be achieved?
In our application we want to connect to our server using LWM2M to exchange some data. To make a connection secure PSK key and indentity needs to be set to lwm2m objects:...
Hi,
I want to run my calibration code only once and this data store in flash (using FDS library) and not again even after restart. Is there any example of this kind of usage...
nRF52832, SD 132, RTOS, SDK13
Can anyone let me know how CPU will do when waiting for a message like below?
evt = osMessageGet(main_msgBox, osWaitForever); //wait...
