Hi.
I am using the NRF52 Development board, on Keil uVision, to implement a C program that uses Dynamic Structs. The Structs re-size themselves ( by increasing their capacity...
Hello,
I have an NRF51822 (redbealab ble nano) that I would like to use to count pulses in very low power mode.
Pulses are asynchronous
The rate of pulses can...
Hi
I'm attempting to read a PT-100 sensor value that is part of a voltage divider using a nRF52.
Both the reference resistor and the PT-100 is sampled while the voltage...
Hi
I have been searching the forums, but were not able to find an answer to my question.
I'm trying to sample 4 analog inputs on the nRF51-DK using the ADC hal. (SDK10...
Hi
I have been trying to get two NRF24L01 chips communicate with each other since a week now, without much success. All what I can find on the net is Arduino examples using...
Hi
I have done several projects with the nRF905. I know the device quite well. Normally I use the CD, AM and DR interrupt pins to determine the status of the device, my current...
i made this project to try to create RSC service on arduino
developer.bluetooth.org/.../runningspeedandcadence.zip
unfortunately the server starts but i'm not able to...
Hello,
I notice that there is a memory region table shown when the program is compiled.
Memory region Used Size Region Size %age Used FLASH: 106392 B 960 KB 10.82% SRAM...
I have a firmware which uses FDS to store configuration, and I want to set some defaults at manufacture. The data might be hundreds of bytes. I could write the data as a binary...
Recently, Nordic released ncs1.7.0, I wonder if it supports the following features:
1. What is the maximum length of broadcast data for extended advertisement? It cannot...
Hey ,
I am currently working on nordic Thingy 9160 .
I was testing this UE and just wanted to know whether we can check the neighbour cell information somehow or not on...
Hi,
In peripheral Advertisement Service. I am trying to add two more parameters(Characteristics Value) under the Battery Service.
Some how it is not creating new characteristics...
I am running the BLE Mesh Light Switch Server Demo
On the mesh stack init phase I encounter following error:
app_error_weak.c, 108, Mesh assert at 0x0002F6E2 (:0)
Debug...
Using nrfConnect 4.5.3 on Android - with a .zip package generated using nrfutil ~3.5.1 I am seeing an error reported at the end of a DFU session. When the update reaches 100...
i am working on current consumption in nrf52832 sdk 17.2.
i have found 2M phy reduces the energy consumption as compared to 1M phy.
i want to set 2M phy GAP aparameter...
Hi everybody,
I am experience a strange thing with dongle.
With a modified Uart example, i modified uart0 pinout to pins rx->1.13 and tx->1.15. I think thats pins are...
Hi I am currently runnign into a problem that my SPI driver does not fire a spi_event after a while.
The code is as follows:
The thing is, it is working at first. My...
Hi!
I was trying to save sensor data to flash and notify it through a dedicated service.
In order to do this I initialized an fstorage instance, created a handler and...
Hi there,
I have the configuration that I have a motion detector connected to a GPIO-PIN of the BM833. Now, when the motion detector detects motion, it will set the GPIO...
