I am trying to find out the part number of the antenna (I assume it is a PCB antenna) used in the nRF51 DK ( www.nordicsemi.com/.../nRF51-DK) . I found a lot of similar questions...
Hi.
I am using the NRF52 Development board, on Keil uVision, to implement a C program that uses Dynamic Structs. The Structs re-size themselves ( by increasing their capacity...
Hello,
I have an NRF51822 (redbealab ble nano) that I would like to use to count pulses in very low power mode.
Pulses are asynchronous
The rate of pulses can...
Hi
I'm attempting to read a PT-100 sensor value that is part of a voltage divider using a nRF52.
Both the reference resistor and the PT-100 is sampled while the voltage...
Hi
I have been searching the forums, but were not able to find an answer to my question.
I'm trying to sample 4 analog inputs on the nRF51-DK using the ADC hal. (SDK10...
Hi
I have been trying to get two NRF24L01 chips communicate with each other since a week now, without much success. All what I can find on the net is Arduino examples using...
Hi
I have done several projects with the nRF905. I know the device quite well. Normally I use the CD, AM and DR interrupt pins to determine the status of the device, my current...
Hello.
I am developing using nrf52832 (S132 v7.0.1, SDK v16.0.0).
During development, I was wondering if advertising and scanning could be done at the same time.
If...
I read several posts on devzone and figured out a workaround for errata 220. I am going to test this after applying it. But the test takes time. So, I would like to hear the...
I'm starting to look at using Ceedling (+Unity + CMock) for some test driven development but am having trouble getting tests that use/mock the SDK. I'm currently trying to...
Hi all. i just want to wake up or put into sleep my device once the user push a button for more than 3s. (the rest of the program works perfectly, also the timmer etc..) I...
Hi,
Kindly give solutions for this error! which needful for our projects, while writing the data on flash memory , written working as perfect, but if I write the data...
Hi.
I have some questions regarding the Heartbeat Example mentioned in this Ticket: Ble mesh heartbeat example - Nordic Q&A - Nordic DevZone - Nordic DevZone (nordicsemi...
sd_ble_gattc_characteristics_discover(conn_handle, handle_range); HI, here conn_handle what parameter need to pass and m_clientService declaration where you did?
Hello
I am using a Nrf52832 kit from Murata japan distributor.( https://wireless.murata.com/mbn52832.html)
My purpose is to be able to perform DTM on above mentioned kit...
Hello,
I am working with Window Covering cluster.
I receive command ZB_ZCL_WINDOW_COVERING_GO_TO_TILT_PERCENTAGE_CB_ID from my coordinator successfully, but I can...
Hello
I need to broadcast large amount of data on MQTT ~ 300K
I require to send it as fast as possible
how can I best calibrate settings for maximal speed send via...
i am using ble_app_uart example on nRF52833 board. I want to make a function that whenever I press button 1 on board, the board will disconnect Bluetooth connection with my...
Hello,
We are developing a BLE beacon with nRF52810 and SDK17.0.0. I modified the code on the basis of ble_app_beacon. I rewrited m_advertising.adv_modes_config.ble_adv_fast_interval...
Dear friends:
The ble advertiser device can advertising, the advertising can be monitored by a smartphone.
The ble mesh node with proxy feature also can advertising, the...
