Hello,
I'd like to ask what is the data rate when using BLE OpenMesh network and how much it depends on network architecture.
I'm considering using it in a network consisting...
Hello Nordic Community,
I need to know how to import my PCB design from Eagle to CST Studio to simulate it and I need to know if the simulation step will be useful to enhance...
Hi.
I'm trying to get Apple notifications to nrf52. And specifically to listen both regular ANS (for android) and ANCS (for iOS) events depending what sort of phone is...
I am trying to find out the part number of the antenna (I assume it is a PCB antenna) used in the nRF51 DK ( www.nordicsemi.com/.../nRF51-DK) . I found a lot of similar questions...
Hi.
I am using the NRF52 Development board, on Keil uVision, to implement a C program that uses Dynamic Structs. The Structs re-size themselves ( by increasing their capacity...
Hello,
I have an NRF51822 (redbealab ble nano) that I would like to use to count pulses in very low power mode.
Pulses are asynchronous
The rate of pulses can...
Hi
I'm attempting to read a PT-100 sensor value that is part of a voltage divider using a nRF52.
Both the reference resistor and the PT-100 is sampled while the voltage...
ble_sdk_app_blinky
Test using nRF Connect
You can also test the application with nRF Connect by performing the following steps:
Compile and program the application...
Hello Nordic support team, I broadcast data each 1 second and I use the following function (as used in many examples) to manage the power consumption. Unfortunately, I measure...
In your example you use as data type 0x09 and I dont understand why.
if I look on the Mesh Specification Mesh Beacon AD Type format
0x00 Unprovisioned Device beacon 0x01...
Hello, i have a central card nrf52840 and several peripheral cards nrf52840.
I have a program that allows me to launch the timer on the central and peripherals at the same...
Hello, I am using Linux as a central and I created python app (bluez, pygatt) which simulates the Android Blinky app. It communicates with the board and writes on the led...
Hello,
I have just started out looking into BLE and have read various articles and a book about the protocol itself. I have got a NRF52DK board and am working on a project...
Hello,
I have a problem with the NRF9E5 (cannot be selected in the list).
For several years we have been using the mentioned chip without any problems. Now we want to...
I am using BLE mesh SDK V1.0.1. I want to know the answers of following questions,
1. What are the advertising and scanning parameters used for flooding in Mesh?
2. Does...
hey, how can i get on the device pca id which is also printed on the nordic chip on the board.
i use the mesh light on off example and need this id to send beacons with...
The code was already done in another system and it worked successfully.But when I tried to build the same code in my system it shows some error like this "cannot move location...
Hello,
I have brought new PCA10056 board for BLE5 evaluation but hard part is board is not getting detected in nRFgo studio nor in Keil.
I can see COM port getting generated...
As we are building our Mesh stack on the Nordic nRF52840 boards we realized that the fixes applied to mbedOS 5.9.4 would fix some of our problems. Does anyone have experience...
Hi!
SDK:nRF5_SDK_15.0.0_a53641a\examples\ble_peripheral\ble_app_ancs_c\pca10056\s140\arm5_no_packs
Development board:pca10056,V0.9.1.
Because the current process of...
