hi:
now.i have a development board(nrfgo motherboard).there is a debug port on the board.i think it can be debugged on the keil.if it can.what driver or others i need.thank...
This is what I got after upgrading my nRF51 dongle firmware.
It always times out.
I didn't somehow got one of my J-Link Lite upgraded, but couldn't repeat the process...
Hi all,
Good day.
Could you please recommend an Android or IOS APP which can connect 8 or more BLE peripherals at the same time.
Thanks & Regards
Jenson
I know that suggested debugger for nRF51xxx is J-Link or openOCD with CMSIS-DAP, but I would like to use BDI3000 debugger, which does support SWD interface and Cortex-M0 processors...
Hello. I am literally looking at the set_hrm_cccd function in Python used to write data. This is for the S130 heart rate collector example. I understand the sd.ble_gattc_write...
Totally new to Python but managed to get things like pyserial setup and I've been able run the ble sniffer. However that is as far as my Python knowledge extends, so I need...
We are experiencing some problems with our code and suspect it is an incorrect formatted printf.
Unfortunately the static code analysis in segger embedded studio (4.52c...
Development Software: nRF5 SDK v15.1.0
Windows 10, 64 bit
I'm following the instructions on how to install the micro-ecc library as detailed on the following page:
http...
I am sending task notification from nus_data_handler when in get BLE_NUS_EVT_TX_RDY event
In a seperate task , i am sending ble packets (244bytes) by using ble_nus_data_send...
Hi Team..,
iam using nrf52832 interface with quectel.iam using uart communication..the problem is when i transmit the AT commands nRF to Quectel that is working fine..but...
Hi,
I am trying to flash the hex file through j-link debugger on nrf52810 controller. Flash is done on hex file but not able to execute after done .
why this problem happening...
We plan to use NRF52805 in our existing boards to add BLE functionality. In the PCB guidelines of the NRF52805 there is a notification about the thickness of the PCB being...
SDK: 17.0.0
Softdevice : S140
Example: ble_app_blink
I modify this example to long range adverting mode,and have some questions as follow:
(1) the device can not connect...
Hi there,
I'm working on a Zigbee project and I'm using the nRF5 SDK for Thread and Zigbee v4.1.0. For benchmarking purposes I need to read the number of hops a Zigbee-packet...
Hello,
I am doing on a project which send data from sensors node to thingspeak, and I am now struggling about implement mqtt to publish data to thingspeak.
best regards...
now i use segger development tool ,but can not breakpoint. but log aseggerlso cannot output information.
V4.2.
my colleague's will do
thanks
best regards!
II'm having issues communicating to the MLX90614, datasheet attached. It seems that I have everything set correctly and the TWI Scanner returns addresses and data. My output...
