Hi,my friend,
Now,I use nrf905.Situation is as follows:
I use the NRF PCB circuit of data manual.Nrf905 work, often loss of data.
1.The Product host is to use the stick...
Hi,
I want to use the Blend Micro with more security. I want use a passkey for the Bluetooth connection. For example through the iOS Device.
Is it possible? Static passkey...
How do I receive multiple signals simultaneously at a single receiver (433MHz) with multiple transmitters ?
I am working on a polling system. This one is similar to the audience...
Hello,
I established a connection between my central and peripheral module. Now i want to write characteristic value on peripheral. I tried with sd_ble_gattc_write function...
I am using the NRF24l01 for my products and looking to buy in bulk(100-1000). Now I know where to buy the just the IC but antenna design is a hard point to break right now...
Hi, my friend,
I've been with nrf905. I use a 16-bit CRC check.
But I encountered problems in use:
1.Nrf905 16-bit CRC check format is CRC-16(IBM):X16+X15+X2+1 or other...
I have two custom PCBs, each of which has a microcontroller and an nrf24L01+. Everything related to the transceiver in the designs are complete duplicates (with the exception...
Hi, in older SDK there seemed to be a simple way to redirect stdout (simple_uart.h), but in SDK 11 I cannot find these functions. What is the recommended/minimal way to redirect...
I use the nrf51822qfaa,s110 v8.00,SDK V10.0.
I use PWM module with a piezo buzzer.
Now I need change the buzzer frequency,
How can I change the PWM frequency?
for example...
I started looking at the alert notification example. I just can't see how people understand the complex state sequences the peripheral (or central for that matter) go through...
I am using em::blocks and arm gcc with ble nano from readbear labs.
I built the template example but it is not working.
The output hex is the same as if i had built it with...
Hi, I am about to purchase PCA10040 V1.1.0.
I heard that one has the latest chip revision nRF52. ( ref. link )
I'm very excited to start with the new feature in nRF52;...
I have a peripheral and a central.I set my peripheral which have the function of static Pin,for example: When I use cellphone to connect to my peripheral , the cellphone must...
Hi all,
I am trying to read and write in ble central and peripheral code with softdevice s130. Here i can able to connect to particular ble device with unique ble device...
When trying to setup the gcc toolchain with Eclipse Luna IDE, I ran into the problem when I can't set a break point when debugging with the GNU ARM J-Link Debugging Support...
Hi,
I am new to Nordic semiconductor's chips. I recently got a nrf52 and I would like to make a portable temperature sensor using nRF52 dk. I have analog sensor that basically...
im using an external acceleromter to trigger an event once the device shaked. I configured the event pin on nrf51 EVENT_PIN as an input this way:
APP_ERROR_CHECK(acc_config_motion_detector...
Hi all,
I can able to blink led in mesh synchronously, but some time it fails in synchronization. when a new node enters into mesh it takes current mesh value, but for...
Hi all,
I am using ble mesh code for synchronizing leds in mesh network. I need mesh part, but itshould not integrated with version. So i can able change state of led,...
