I am trying to create an nRF8001 based application that will broadcast battery levels (pipes broadcast, set), and give out temperature data (pipe indicate - TX_ACK) to connected...
Hi,
I'm using redbearlab's nrf51822 board. It is a arduino compatible board and hence it is using 0,1 (mapped to 9 and 11 for nrf51822). How do I make printf print to this...
An external PA/LNA is used to extend range of nRF51822, and S110 is used for BLE, How to switch between PA and LNA? and how to disable PA/LNA when there isn't transceiving...
Hi...
Can anybody help me to run ble_peripheral example (ble_app_hrs for S130). I have build and load the code successfully but cant see the advertisement. But while debugging...
I am working with the nRF8001, and I'd like to create a services.h file that will let me broadcast battery level and as well as allow temperature to be read by a peer.
...
Hi We have an application where we what to read i2c sensor data over the air to an iPhone. We've taken ble_app_uart_S130 project and grafted in some twi_hardware code. There...
I am interested in the S130 ability to hold 3 central -> peripheral links over BLE, and am looking for some evidence that this has been accomplished with extremely low-power...
Hello.
The other day, I purchased Nordic's BLE module and started developing a multirole program. The development environment is
・Use project:ble_app_multirole_lesc_s132_pca10040...
Hi Nordic team,
I have 2 nRF52 Development kits. I want to use one of them as sniffer.
Please let me know if this is possible.
If possible please let me know where can...
I am going through the latest version of the Getting Started Assistant on an x64 Ubuntu 18 machine, using the v.1.0.0 tagged SDK release. When I reach the step "The nRF Connect...
I would like to program my NRF52840 device using the Keil Ulink2/pro JTAG device.
I have been able to do a full chip erase using the Keil Ulink 2 device, but when I attempt...
Hi,
I'm using nrf52832 with s132, so I don't find any information about the current consumed by the device when I'm connected by Bluetooth. I use the driver st7735 and an...
How a device in mesh of ble controlled by internet.
I tested light on/off of mesh and it works fine.
but how can I control it from internet.
like with wifi or ethernet...
I'm trying to figure out how I can store a text file on the device and access it while the device is running. I'm having a hard time finding documentation on the best way...
We are using the nRF52840 SPIM0 to read 2048 bytes from an SPI slave. ( SES / SDK15.3 )
The nrf libraries only seem to support a maximum of 255 bytes, so we have compiler...
To the kind attention of Nordic support team,
We are going to use gazell protocol for some of our wireless products. Could you please point me out to the relevant documentation...
Dear All,
I am trying to integrate the simple_at example to my own application, in order to be able to configure the modem in the beginning and then run my code.
I can...
Hi,
I'm trying to use the nrf_drv_spi.c to communicate with a BL652 + MCP2515 CAN SPI custom device. I've connected the MCP2515 to the nRF52832 (BL652 module) in the following...
as others have described I run the sniffer
than go through pairing process, the encrypted packets show up as "Encrypted packet decrypted incorrectly (bad MIC)"
is there...
